How much is it to replace the throw-out bearing?
A throw-out bearing will cost you anywhere from $30-$100. The price of a new clutch can vary greatly depending on the vehicle but most cost somewhere in the range of $300 to $800. A new flywheel (if needed) will set you back another $50 to $200.
What to look for when replacing a throw out bearing?
Inspect the pressure plate for any scoring, grooves and chips. Also, inspect the flywheel for any rivet grooves, warping or gouging. Surfaces should be smooth. Make sure all teeth on the flywheel are also in good shape.
What kind of transmission does a Mercedes 300D have?
I have a 1981 Mercedes 300D W123 with the OM617.952 turbo diesel and auto transmission from a 1984 300TD wagon that I swapped in. I was at a local Pull’n’Save and found a 1979 240D W123. It had the 4 speed manual tranny.
When did the Mercedes 300D 4 speed manual come out?
The 81 models didnt have the turbo diesel motor. It was introduced in 82. I pulled the motor out of a wrecked wagon i have as a parts car. For the SLS pump on the head, i took the pump off and cut out a metal plate that i drilled holes in and bolted over the hole. i used some gasket paper and silicon, and no leaks.
What does a throw out bearing on a clutch do?
The throwout bearing is a small bearing that assists in the disengagement of the clutch. The bearing allows the clutch to smoothly operate within the gear box and is essential for proper clutch function.
When do you change the throw out bearing on a car?
The bearing allows the clutch to smoothly operate within the gear box and is essential for proper clutch function. When and if you are changing the clutch, change the throwout bearing also. Replacing a throwout bearing is simple and can be accomplished by any do-it-yourself mechanic. Drive the car up on the wheel ramps and set the parking break.
The throwout bearing is a small bearing that assists in the disengagement of the clutch. The bearing allows the clutch to smoothly operate within the gear box and is essential for proper clutch function.
When to replace a release bearing on a flywheel?
Inspect the pressure plate for any scoring, grooves and chips. Also, inspect the flywheel for any rivet grooves, warping or gouging. Surfaces should be smooth. Make sure all teeth on the flywheel are also in good shape. At this point, inspect the release bearing and replace it if worn. Check the pilot bearing for wear and replace if necessary.