How much HP can a built Ford 9 inch handle?
Like red91xlt just mentioned its also the question of tires. Sure a 9 inch can handle 400+ horse in a car.
How much torque does a front axle nut have?
Description: FWD, RWD & 4 W/D front axle nut torque specifications Front proc. Rear proc. Make or torque or torque year Model ft-lbs/Nm ft-lbs/Nm Front proc. Rear proc. No Text Content!
What happens when you torque a pinion nut?
The marking of the nut on the pinion will put you very close to the org. torque if you are just changing the seal and not messing with the crush sleeve or shims.. It will put it back because the crush sleeve is already crushed to the point where pre load is, or should I say was set.
Where can I find the torque specification guide?
Ensure that you have the correct torque for the application by referring to SKF 457377 torque specification guide or contact the vehicle manufactures dealer. It is important that you properly torque the spindle nut to ensure optimum bearing life. Under torque of an axle nut will allow excessive movement causing uneven loading and excessive wear.
What happens if your spindle nut is over torque?
It will also leave your spindle nut under or over torque resulting in hub assembly failure. Ensure that you have the correct torque for the application by referring to SKF 457377 torque specification guide or contact the vehicle manufactures dealer. It is important that you properly torque the spindle nut to ensure optimum bearing life.
What is the spec on a pinion nut?
If you are talking about the pinion nut it is not hand tighten. The spec measures the torque required to turn the pinion gear by itself once the nut is tightened. The spec is NOT the torque applied to tighten the nut. That is whatever it takes to achieve the pinon bearing pre-load which is determined as described above.
What are torque specifications for Chevy axle nut?
2012-2017 There are two types of wheel drive shaft nuts, both of which have different tightening torque specifications. Check the style nut that is on the vehicle when staking the nut. Style 1 nut has the thin collar (1.5 mm) thickness. Style 2 nut has the thick collar (2.7 mm) thickness.
What are the torque specs for front suspension?
Front Suspension Torque Specs Description Specification Stabilizer Bar Retainer Bolts 45 ft-lbs Stabilizer Bar Link Upper Nut 75 ft-lbs Stabilizer Bar Link Lower Bolt 75 ft-lbs Track Bar Frame Bracket Nut 125 ft-lbs
How big is the torque cap on a pinion?
Pinion Preload (Reused) Ring Gear Backlash Ring Gear Bolt Torque Carrier Bearing Cap Bolts Chrysler 7.25″ 12 to 14 in-lbs. 6 to 7 in-lbs. .006″ to .010″ 55 ft-lbs.