How many volts does a 16 Volt DLC have?
Pin 16 is 12 volts all the time for all makes of vehicle. TIP WHEN YOU ARE NOT SURE ABOUT THE VOLTAGE READING Get hold of a wiring diagram first so you will know what pin at the DLC is working.
Where is the 16-pin diagnostic connector ( DLC )?
The EOBD / OBDII 16-pin diagnostic connector (DLC) Where is the connector? The EOBD connector is required by the Directive to be located within the passenger compartment of the car, within reach of the driver’s seat. Tools should not be required to reveal the connector, but it may have a removeable cover over it.
What should the voltage be on a 6 pin connector?
The pins should be +12V or 0V (ground). If the wire going in is yellow, the corresponding pin should be +12V. If black, 0V. Rofl, for some reason I was try to answer the question as if Route44 asked how much power the 6-pin connector provides.
When did pin 2 change from 5 volts to 7 volts?
Pin 2 could vary between 5 volts to 7 volts depending on the make of the vehicle from 2003 to 2005 model for GM and Chrysler vehicles but cold change to zero volt in 2007 model. Ford vehicles showed change to zero volt in 2005 upto 2008. Toyota vehicles on the other hand stayed at zero volt from 2003-2007.
Pin 16 is 12 volts all the time for all makes of vehicle. TIP WHEN YOU ARE NOT SURE ABOUT THE VOLTAGE READING Get hold of a wiring diagram first so you will know what pin at the DLC is working.
The EOBD / OBDII 16-pin diagnostic connector (DLC) Where is the connector? The EOBD connector is required by the Directive to be located within the passenger compartment of the car, within reach of the driver’s seat. Tools should not be required to reveal the connector, but it may have a removeable cover over it.
How can I measure the voltage of my DLC?
Since most of these 16 pin terminals of the DLC are used to communicate with your vehicle modules, you can use the following guide to measure the power, ground and signal data link voltages readings as shown below. 1.) With your voltmeter negative lead connected to the battery ground post and positive lead connected to following terminal pins:
Pin 2 could vary between 5 volts to 7 volts depending on the make of the vehicle from 2003 to 2005 model for GM and Chrysler vehicles but cold change to zero volt in 2007 model. Ford vehicles showed change to zero volt in 2005 upto 2008. Toyota vehicles on the other hand stayed at zero volt from 2003-2007.