How long can Harley Davidson oil sit?
Type Of Oil Used For motorcycles needing mineral-based motor oil, these engines can typically run 2,000-3,200 miles before needing to change the oil. Motorcycles needing semi-synthetic motor oil can usually last between 5,000-8,000 miles before needing to change the oil.
Does a Harley burn oil?
a Harley motor will run on 16 oz of oil ,so don’t be afraid to run it with 3 quarts ,if that’s what it likes.
Are Harley Shovelheads reliable?
If you follow the specs in the book and use good quality parts and have your machine work done properly, the Shovelhead is as reliable as any other motorcycle, Otherwise, it will leave you by the side of the road every time.
What causes an oil leak on a Harley Davidson?
Depending on how/if the engine was rebuilt, there’s ALOT of reasons that could happen. Blocked return holes. Partially restricted pushrod tubes. Improper oil pump timing. Improper head venting. Excessive blow-by due to worn rings. Also, one other thing that can cause it, if none of the above fixes your problem.
How to fix an oil leak in an Evo?
This product can be found many places, one source is: www.eastwood.com Genuine Red Glyptal Imporves Oil Circulation Recommended by many high performance engine rebuilding books, Glyptal seals the tiny pores. Real Old HD motors had problems weeping right thru the case, fix was to split the cases & paint the insides with RED GLYPTAL….
What causes an oil leak on a V-twin?
The primary oil is pulled into the motor oil system and overflows out the crankcase vent. The crankcase is vented to the bottom of the bike. I have changed the oil seal on the crankshaft twice (turning it both ways) and still leaks. Today, I realized I had the main oil feed line from the tank hooked to the oil filter.
What can cause 1989 Harley pukes oil out crankcase vent?
Re: 1989 harley pukes oil out crankcase vent when started… Blow by compression. Severe engine problems. Pull the heads look at cylinder walls You can’t post conmments that contain an email address. I have 1983 Harley Sportster 1000 that won’t fire when I first turn the key, but after a few minutes it fires right up what can cause this?
Depending on how/if the engine was rebuilt, there’s ALOT of reasons that could happen. Blocked return holes. Partially restricted pushrod tubes. Improper oil pump timing. Improper head venting. Excessive blow-by due to worn rings. Also, one other thing that can cause it, if none of the above fixes your problem.
How to change the oil in a Harley Davidson?
Make an extension, so you can run this line downward and into an oil drain pan or container. Verify that you have enough oil in your oil tank and let this m/c run for a little while. This will evacuate the rest of the lingering, old, oil. After this is resolved, be sure to change your oil & filter. 1988 Harley Davidson FLHS – My Name is Michael.
What does oil sumping on a Harley mean?
Hello Larry,This problem is known as oil sumping, it happens when then gravity and static pressure of oil in the tank located above the oil pump push the check ball upward and oil drips into the crankcase. Below the flywheels locate the breather hose and put it into a 2 liter soda bottle.
This product can be found many places, one source is: www.eastwood.com Genuine Red Glyptal Imporves Oil Circulation Recommended by many high performance engine rebuilding books, Glyptal seals the tiny pores. Real Old HD motors had problems weeping right thru the case, fix was to split the cases & paint the insides with RED GLYPTAL….