How does the Idle Stop Start system work?
The Stop-Start system will then automatically restart the engine when the driver lifts their foot off the brake pedal and/or presses down on the accelerator. The restart is supposed to be instantaneous and seamless, though there may be a slight lag in some situations.
How to adjust throttle control on a car?
Pull until the cable is taut, then tighten the clamp screw. NOTE: The engine control lever should be against the high idle RPM stop bracket. 6. Move the application throttle control to the slow position, then to fast. Check the engine control to assure it stops against the high idle RPM stop bracket.
When to move throttle control to slow or fast?
Move the application throttle control to the slow position, then to fast. Check the engine control to assure it stops against the high idle RPM stop bracket. NOTE: When the application throttle control lever is in the slow position the engine governor spring must be free of tension or pushing pressure. A non- free spring can affect the RPM.
What happens when you open the throttle on a gas engine?
This will cause a phenomena called “puddling” where little droplets of gasoline adhere to the intake manifold runners. When the throttle is opened, there is now sufficient velocity of air to sweep all these droplets into the cylinders, creating a mixture which is too rich to burn, hence the bog.
Pull until the cable is taut, then tighten the clamp screw. NOTE: The engine control lever should be against the high idle RPM stop bracket. 6. Move the application throttle control to the slow position, then to fast. Check the engine control to assure it stops against the high idle RPM stop bracket.
Why do I have to crank the engine for longer than normal?
Battery is strong, but I have to crank the engine for 3-4 seconds instead of the usual 1 second to start the engine. Thought it might be fuel filter, but searched and found it’s in the tank as part of the fuel pump assembly. Recently had fuel tank seal recall done, but my issue with starting was happening before this.
Move the application throttle control to the slow position, then to fast. Check the engine control to assure it stops against the high idle RPM stop bracket. NOTE: When the application throttle control lever is in the slow position the engine governor spring must be free of tension or pushing pressure. A non- free spring can affect the RPM.
Where is the throttle cable on a magnum twin?
Engine Throttle Control Lever (Shown in Low Idle Position) Throttle Cable (Under Cable Clamp) Constant Speed Control (When Remote Cable is Not Used) Optional Throttle Cable Bracket Location High Idle RPM Stop Bracket Screw High Idle RPM Stop Bracket Governor Spring Throttle Control Wire 6 Magnum Twin Horizontal 5.