How does the blower motor speed controller work?
If what you mean by “Control Module” is the the electronic controls in the dash, that control module sends a signal to the blower motor speed controller. https://www.rockauto.com/catalog/moreinfo.php?pk=2417088&cc=1431202&jnid=509&jpid=6 If the speed controller fails, the blower fan will run all the time. Bing July 6, 2016, 6:27am #5
What happens if the blower controller has failed?
If the blower controller has failed as mentioned it’s also possible that it failed because the blower motor is failing. When the blowers get some age on them the current draw increases dramatically and that means a lot of additional heat. In some cases the blower controller connector will burn or even melt to some degree.
Why does my blower not work at high speeds?
Blower works on slow speeds, but not on high speed. Check for bad fuse or bad high speed relay. Swap the high speed relay with another relay with the same part number. Also, check the fuse for the control side of the high speed relay. Make sure the ground side of the high speed relay is working. Blower works on some speeds but not others
What should I do if my blower motor stops?
Replace blower motor. If you have a variable speed blower motor, replace the blower motor speed control module. If you have a three or four speed blower motor, remove the blower motor relay. If the motor stops, replace the relay. Alldatadiy.com and Eautorepair.net are professional-grade shop manuals—period.
How is the speed of the blower motor controlled?
The blower resistor is connected in series to the blower fan motor. This means that the current running through the blower motor, and its’ speed is therefore controlled by the resistor value. The user chooses a fan speed by selecting a speed which then connects one of the resistors in the blower resistor pack.
Why is the blower motor not working on my car?
My car has an automatic transmission. Hi There, The resistor is what controls the speed of the blower motor, not the relay. The blower motor relay supplies power to this motor when you turn the switch to “on” that can sometimes fail. When this happens, you may notice that you will not feel anything blowing out of the vents at all.
Why is my blower not working in Hi ( 5 )?
The usual failure of the resistor pack is if it works in HI (5) but not in any other mode or just a few modes. When you switch to high,the blower motor relay coil circuit is grounded and voltage is now applied directly through the relay to the blower motor; bypassing the resistors. So, I would look to see if the relay is ok.
Why is the resistor not working on my blower?
Hi There, The resistor is what controls the speed of the blower motor, not the relay. The blower motor relay supplies power to this motor when you turn the switch to “on” that can sometimes fail. When this happens, you may notice that you will not feel anything blowing out of the vents at all.