How does the auto hold light work on a Hyundai Tucson?
The Hyundai Tucson auto hold light illuminates white when the system is activated by pressing the auto hold button. It illuminates green when the vehicle is stopped by the foot brake and the auto hold system is operational. The auto hold button illuminates amber when there’s a fault with the system.
Are there any problems with the Hyundai Tucson?
Check out our Hyundai Tucson overview to see the most problematic years, worst problems and most recently reported complaints with the Tucson.
When to use lock mode on Hyundai Tucson?
The Hyundai Tucson 4WD lock mode is to increase the drive power when driving on wet, slippery pavement, snow covered roads and/or off-road. Lock mode should not be engaged on dry roads as this can potentially damage 4WD related components.
When does the Hyundai Tucson master warning light come on?
The amber triangle containing an exclamation mark is the Hyundai Tucson master warning light. The warning light comes on along with a message when a maintenance issue or non-critical malfunction occurs. For example: low washer fluid, Blind Spot Detection (BSD) malfunction, Tire Pressure Monitoring System
What causes a Hyundai Tucson to not start?
Find out why your car won’t start and what you can do about this problem. A Hyundai that doesn’t start can have a range of causes including dead battery, poor battery connection, dead key fob, broken starter, blown fuse, fuel pump failure, clogged fuel filter, empty fuel tank, defective spark plugs or any other electronics failure.
Can a power window fail on a Hyundai Tucson?
Your Hyundai Tucson’s power window motors can and do fail over time. You’ll have to take the door panel off to get to it. A lot of them are riveted in, so be prepared to deal with that.
What should the voltage be on a Hyundai Tucson?
Connect the red wire of the multimeter to the positive terminal of your car battery. The black cable goes to the negative pole. The voltage should be between 12.4 and 12.7 volts at best. If it is below 12V, something is wrong.
What to do if your Hyundai keyless entry stops working?
However, if the keyless entry system on your Hyundai stops working, you don’t have to call a Hyundai dealership or service center for a replacement just yet. In most cases, these simple troubleshooting tips will have your Hyundai keyless entry system working again in just minutes.