How do you take care of a Mazda RX8 engine?
Here are a few of the common failure points on RX-8s, and how to prevent them.
- Failed apex seals.
- Use dino (non-synthetic) oil only.
- Allow the engine to reach redline at least a few times a week.
- Allow the engine to warm up.
- Perform a compression test with some regularity.
What to do if your Mazda RX-8 won’t start?
If the lights anywhere in your car are not turning on, your battery may be dead. Check to see if you can start your engine. If the engine turns on then your battery should be working properly. However, if the engine will not start, refer to the Car Cranks But Won’t Start .
When did the Mazda RX-8 come out?
This category covers 2004, 2005, 2006, 2007, 2008 Mazda RX-8 Troubleshooting models. Your guide to finding the problems with your Mazda RX-8 so you can effectively and efficiently resolve them.
What causes wheel replacement signal on Mazda RX-8?
It also could be a sensor malfunction, a wire loose, or some other minute detail that is upsetting the complex computer of the Mazda RX-8. If you have installed aftermarket wheels with different sizes front to rear, that may cause a false sensor signal to the ECU, please look at Wheel Replacement guide.
Why is the oil in my Mazda RX-8 so dirty?
As you drive the car the oil picks up impurities in the engine and can lose some of its lubricating properties. Because in the RX-8 the oil is introduced inside the engine it is even more important that the engine oil remain clean and fresh.
If the lights anywhere in your car are not turning on, your battery may be dead. Check to see if you can start your engine. If the engine turns on then your battery should be working properly. However, if the engine will not start, refer to the Car Cranks But Won’t Start .
As you drive the car the oil picks up impurities in the engine and can lose some of its lubricating properties. Because in the RX-8 the oil is introduced inside the engine it is even more important that the engine oil remain clean and fresh.
This category covers 2004, 2005, 2006, 2007, 2008 Mazda RX-8 Troubleshooting models. Your guide to finding the problems with your Mazda RX-8 so you can effectively and efficiently resolve them.
Why does my Mazda RX-8 stall at 3000 rpm?
The rough idle appeared to go away after driving a long highway trip where RPM tended to remain above 3000 for long periods. I believe there are two things going on with the RX-8 AT. The engines simply need to run at least at 3000RPM to keep everything clean and clear.