How do you reset the ECM on a Harley Davidson?
Turn off the ignition and click the “Run/Stop” switch to “Run.” Press and hold the odometer reset button. Turn the key to ignition and let go of the odometer reset button. The cluster will illuminate and the odometer will read the word “Diag.”
What does the ECM do on a Harley Davidson touring?
The ECM is the computer on your Harley Davidson Touring that reads the sensors and tells the motor what to do. Resetting it allows it to start fresh and relearn any mods you have made. This article applies to the Harley Davidson Touring (2000-2015).
Why does my Harley Davidson go into limp mode?
As soon as possible afterwards though, you should get your bike checked over to find the reason why it went into limp mode in the first place. One of the more common reasons for limp mode are corroded or lose pins on the ECM itself, exasperated by rough or bumpy roads.
Why does my ECM go into limp mode?
One of the more common reasons for limp mode are corroded or lose pins on the ECM itself, exasperated by rough or bumpy roads. Many people also believe that any modification made to the bike requires an ECM reset; however, this should not be the case. After a few cycles of starting and stopping, the ECM should learn your new setup on its own.
Are there any problems with the Harley Davidson clutch?
This recall involved problems with the clutch system which won’t fully disengage. In the report, Harley-Davidson said this is the result of gas bubbles in the master cylinder clutch. If you’re considering these models, check with the dealer to make sure that the clutch got flushed or the master cylinder got rebuilt.
How to get the ECM code on a Harley Davidson?
The following procedure will instruct in retrieving and clearing ECM Diagnostic Trouble Codes and TSM/TSSM codes through the Harley guage cluster as well as a list of codes. 1- Turn Ignition switchto OFF & Run/Stop switch is to Run. 2- Push odometer resetbutton in & hold. 3- Turnignition switchto Ignition and release the odometer reset button.
How to view and clear Harley diagnostic trouble codes?
Viewing and clearing DTC’s: (Clear codes at your own risk)(Make sure you know what you are doing or consult a Harley mechanic) Push the odometer button and release to scroll through the different modules and codes. If an item has a “Y” next to it then you have trouble code.
How to check ECM code on fuel Moto?
Fuel Moto does not offer technical support for diagnostic trouble codes. The following procedure will instruct in retrieving and clearing ECM Diagnostic Trouble Codes and TSM/TSSM codes through the Harley gauge cluster as well as a list of codes. 1- Turn Ignition switch to OFF & Run/Stop switch is to Run. 2- Push odometer reset button in & hold.
What causes a high temp ECT on a Harley Davidson?
P1019 ECT Difference (high temp) Possible causes: ECT sensor malfunction. No air flow through radiators. Low or no coolant in system. Could also be wiring, cooling pump or ECM. Diagnostic test: 1. Check radiators are clean & free of debris. Verify coolant level. 2. Cooling pump test.