How do you replace the speakers on a Ford Mustang?
To replace the factory speakers, begin by prying the grilles up from the rear deck. Once you have the screens off, remove all of the Torx screws that secure the speakers, and lift each unit from its respective bracket. Disconnect the speakers from the internal wire harness, and discard the factory units.
Where is the stereo system on a Ford Mustang?
Factory stereo system. The factory stereo is located at the front of the car’s center console. The AM/FM/CD receiver lives in a double-bay assembly, and Ford offered three audio system options: 4-speaker system: Features 6″x8″ speakers in the front doors and on the rear deck, powered by a AM/FM/CD receiver.
What’s the best way to remove a Torx speaker?
You’ll start by prying up and removing the top part of the side panel, then you’ll pry the panel out until you release the retaining clips. You won’t remove it all together, though. Hold it out far enough to remove the four Torx T20 screws that secure the speaker, then pull it out, disconnect it, and remove it.
Can you put a radio in a Mustang Shaker?
Installation note: The mounting kit that trims out the new radio in the Mustang dash includes a pocket that protrudes a little. As a result, you can’t install a car stereo with a fold-down face in this Mustang. You’ll go through the same procedure to remove the radio in the Shaker systems, with one change.
To replace the factory speakers, begin by prying the grilles up from the rear deck. Once you have the screens off, remove all of the Torx screws that secure the speakers, and lift each unit from its respective bracket. Disconnect the speakers from the internal wire harness, and discard the factory units.
Factory stereo system. The factory stereo is located at the front of the car’s center console. The AM/FM/CD receiver lives in a double-bay assembly, and Ford offered three audio system options: 4-speaker system: Features 6″x8″ speakers in the front doors and on the rear deck, powered by a AM/FM/CD receiver.
You’ll start by prying up and removing the top part of the side panel, then you’ll pry the panel out until you release the retaining clips. You won’t remove it all together, though. Hold it out far enough to remove the four Torx T20 screws that secure the speaker, then pull it out, disconnect it, and remove it.
Installation note: The mounting kit that trims out the new radio in the Mustang dash includes a pocket that protrudes a little. As a result, you can’t install a car stereo with a fold-down face in this Mustang. You’ll go through the same procedure to remove the radio in the Shaker systems, with one change.