How do you replace the core on a Honda Civic?
Disconnect the heater hoses from the core housing; squeeze open the hose clamps using a pair of vise grips and remove the mounting wing nut from the heater unit by turning it with your hand until it comes free. Remove the center console from the interior of the vehicle using the screwdriver.
How do you replace a civic heater shaft?
Use a piece of heavy tape to secure the shaft sliding cover onto the steering column while it is removed. Remove the hoses by opening the spring hose clamps using the vise grips. Remove all remaining wires. Remove the harnesses and retainer bolts using the Phillips screwdriver.
What happens when you turn off the heater on a Honda Civic?
Since you are disconnecting the power from the battery, these systems will reset to the factory defaults and will need to be unlocked when you restore power to the car’s systems. Do not attempt this repair unless the warranty has expired–this is one of the systems covered by the car’s no touch policy.
How do you get coolant out of a civic heater?
Drain the coolant from the radiator by opening the drain plug on the bottom of the radiator. Use an approved drain pan to collect the coolant and dispose of it in a method compliant with the laws of your community. Remember this substance is poisonous. Open the cable clamp located under the hood and disconnect the heater control cable.
How to replace heater core in Honda Civic Forum?
Pull the center console panel up and rearward to release the tabs . Open the armrest then remove the console mat and bolts. From the front portion of the center console, remove the bolts and clips . Slide both front seats all the way back, and recline the seat backs fully. Slide the center console rearward to release the pins from the bracket (C).
How do you replace a Honda Civic evaporator core?
1. Disconnect the negative battery cable from the battery. 2. Recover the refrigerant with a recovery/recycling/charging station. a. Disconnect the A/C line from the evaporator core. b. Remove the bolt. c. Remove the nut, and then disconnect the A/C line (A) from the evaporator core. 3.
Where is the heater core on a radiator?
The heater core is on the left side bottom. Remove the self-tapping screws, the heater core cover, and the grommet and carefully pull out the heater core. 15. Install the heater core. 16. Install everything in the order they were taken out. Fill the radiator with coolant and make sure you check everything before starting.