How do you replace a shock absorber on a SEAT Ibiza?
Jack up the rear of the car on both sides, and support securely with axle stands. Remove both rear wheels. Using a jack, just take the weight off the rear suspension arm on one side. Remove the lower bolt from the shock absorber, as in the following photo:
How do you replace a Ford rear shock absorber?
On some Ford products there’s an external motor drive, and you can unplug it from the old shock and install it on the new one. In most other cases, you get a choice of shock absorber designs. If the shock rod spins endlessly as you try to remove the upper mount, try Vise-Grips on the flatted end of the rod.
How do you remove power seats from a car?
Locate the four mounting bolts holding the seat to the floorboard. There are two in the front and two in the back. Slide the seat all the way back for room to remove the front two bolts. Unfasten the front two bolts using a socket wrench and put aside. Slide the seat all the way forward to gain access to the back bolts.
How to replace your own shocks and struts?
How to replace shocks and struts 1. Check whether you need a spring compressor. On many cars, the struts/shocks and springs are interrelated or… 2. Securely raise one side of the car. If you’ve got access to an actual lift, great. Driveway DIYers everywhere are… 3. Remove the wheel and extract …
What’s the best way to replace a rear shock?
Use penetrating oil if needed to loosen the bolts and nut. Use a socket wrench and 10mm socket to remove the splash guard bolt, and splash guard. Then, remove the bottom nut using a socket. Next, remove the top bolt (s) with your socket.
What’s the best way to remove the back seat?
From inside the car remove the two bolts holding the lower section of the back seat using the T40 socket. with the lower section out of the car you can replace the two bolts so you don’t lose them. Using the T45 socket remove the mounting points for the 3 rear seat belts, middle and both sides.
How do you remove studs from a shock mount?
When you get the nuts off a stud mounting, you still have to pry off the shock, working evenly at top and bottom so it doesn’t cock. If you’re not sure of the condition of a bone-dry shock, just disconnect it from the bottom mount if possible (or remove it completely if it’s on studs).
How do you install shocks on a Harley Davidson?
Raise the wheel (easier with a helper) to align the hole and install the lower shock mounting bolt. Install the other shock in the same way, remembering to clean and put a drop of blue Loctite on each mounting bolt. Tighten all four mounting bolts to 35 to 40 foot-pounds.