How do you replace a safety switch on a Jeep Wrangler?
Use a wrench to loosen and remove the screws that hold the safety switch on the transmission. Let the transmission fluid flow into the container. Install the new switch and gasket and tighten the screws with a wrench. Tighten the screws with a torque wrench to 24 foot-pounds of pressure. Connect the wiring harness to the switch.
Where is the neutral start switch on a Jeep Wrangler?
The neutral safety switch — or neutral start switch — is an important safety component in your Jeep Wrangler. It prevents the engine from starting while the transmission is in a drive gear. The neutral safety switch and backup light switch are combined in one unit. The switch is located on the transmission oil pan.
Why is the ignition switch on my Jeep not working?
Sometimes Jeeps won’t start but all the electronics work. It might be a faulty ignition switch keeping your Jeep from starting. This video is a how-to for replacing the Start Ignition Switch Actuator Pin; a known weakness in our beloved Jeeps. If you aren’t sure why your Jeep won’t start, this probably IS NOT your issue because it is rare.
Can you replace the ignition switch on a 1998 Jeep Wrangler?
Replacing the ignition switch on a 1998 Jeep Wrangler entails removing the ignition switch tumbler, as well. A point many times confused is the separation of the two related parts. The key, also called the tumbler, has no electrical function; its function is strictly related to vehicle security.
What’s the ignition timing on a Jeep Wrangler?
But one of the largest pieces of this four-cycle puzzle that’s sometimes ignored is ignition timing. For optimal performance and reliability, a few lessons in ignition timing can go a long way. Though modern Jeep Wrangler ignition systems have much in common with their predecessors, a few things separate each system from each other.
Where is the ignition key on a 1998 Jeep?
Place the ignition key in the tumbler and turn it to the “On” position. With the small Phillips screwdriver or the scribe, stick it into the hole in the ignition switch, located directly behind the tumbler.
Why was the ignition system of a Jeep Wrangler so bad?
The ignition system had its flaws due to its mechanical nature—especially because it was dialed in by the human hand. Understand that many things can affect how the engine runs and what it needs in order to run well. The time of the ignition would be something subjected to adjustment in order to run right.