How do you remove the ignition switch on a Honda motorcycle?
Just be sure to check your owner’s manual for any additional information you might need.
- Step 1 – Position the Motorcycle.
- Step 2 – Disconnect the Battery.
- Step 3 – Loosen the Pinch Bolts.
- Step 4 – Remove the Damper.
- Step 5 – Remove the Triple Tree.
- Step 6 – Remove the Ignition Switch.
How do you change the ignition key on a Honda?
1. Remove the right hand fairing side panel 2. Disconnect the 2-pin wiring connector on your CKP sensor. 3. Shove your DIY special tool into the connector and connect the positive and negative battery connectors to their respective battery terminals. 4. Turn the ignition key to ON using your original key.
Where do you find the key code on a Honda?
Most locks from the 60’s and 70’s have the key code on the face of the lock. The number can be obtained from the Ignition, Helmet, or Steering Lock. See the example photo’s at the bottom of the table. Late 70’s and later, the code numbers are on the back of the locks. Usually the lock must be removed.
Can a Honda engine be started without an original key?
The electronic immobilisers Honda Ignition Security System (H.I.S.S.) makes sure that the engine can only be started when using an “original key”. The system cannot be bypassed by either hot-wiring the ignition or exchanging the ignition switch module.
Can a Honda Civic ignition lock be repaired?
Either with time or due to mishandling the levers of Honda Lock gets damaged. You may replace or remove defected levers completely to make the lock working. This repair is valid on all Honda Cars including City, Civic, Accord, Jazz, Brio, CR-V Loading…
What to do if your Honda Civic key wont turn?
The easiest and most economical option is to simply replace the lock cylinder. This is the same assemble for the Honda Accord, Element, Civic, CrossTour, Fit, Insight, and Odyssey. Here is the link for the lock cylinder and 2 replacement keys to go with it: And if you just need a new set of key blanks, these are the ones you need:
How do you get ignition cylinder out of Honda?
I had to drill out this pin to get the ignition cylinder out. Choose a small drill bit, small enough to fit into the center of the dowel pin. Drill into the pin (it has a hollow core), then it will adhere to the drill bit, and you can pull it out.
Why does my Honda Accord key not turn?
The ignition switch on my 2004 Honda Accord developed a problem. The key simply woul not turn in the ignition! I was finally able to get it to turn one day after I jammed one of the keys in to the ignition to get it to turn. But unfortunately, after that, the key would not turn in the ignition!
What kind of grease to use on Honda Key?
If you go with something too heavy, like a silicone based grease it will harden and make the key gummy. You also don’t want to go with something too light like WD-40, that will dry everything out. This is some good lithium grease for this job.