How do you remove lower ball joint on Nissan Navara Fixya?
Disconnect the caliper and mount, and hang it aside. Unbolt the 5 or 6, 6mm allen head bolts from the hub. Pull the hub out and remove the snap ring and washers behind it. Loosen the upper ball joint nut a little and break the joint free. Support the lower control arm with a jack and loosen the lower ball joint nut and break it loose also.
How do you remove the lower ball joint?
Loosen the upper ball joint nut a little and break the joint free. Support the lower control arm with a jack and loosen the lower ball joint nut and break it loose also. With the lower control arm supported, remove the upper ball joint nut and slowly remove the lower control arm support (jack).
How do you know if ball joints need to be replaced?
Inspect the ball joints to make sure they need to be replaced. Figure out if your vehicle’s got a strut-style suspension or a control arm, then check the ball joint by either jacking up the control arm near the ball joint to check for wheel play, or by jacking up the car and using a pry-bar to check for wheel play in a strut-style suspension.
How do you put a new ball joint in a car?
Slide the new rubber boot over the ball joint’s stud and guide the new ball joint back up through the steering knuckle hole, where it came from. Bolt the joint into place using the hardware included.
How to replace a lower control arm ball joint?
Replacing a Lower Control Arm Ball Joint. Learn how to replace a lower ball joint by pressing it out of the control arm and pressing the new one back in. To watch the longer, in depth version, click the link below. Press out a Ball Joint (In-depth):
Where is the ball joint on a Nissan Frontier?
Once that came lose I set the spindle and brakes on a small stool next to the control arms, because the speed sensor wire was still attached. Now that the spindle is out of the way, you have free access to the lower control arm and ball joint.
Can a lower ball joint be replaced in a four wheel drive car?
Once you have the lower ball joint in place and tightened you can start putting things back together. Four wheel drive owners, be sure to put your axle back in place. Align the spindle back on with the lower and upper ball joints first, tighten the nuts on and place the cotter pins back in place.
How big are the nuts on the lower ball joint?
The first is the nuts on the upper ball joint and tie rod are 22 mm while the one on the lower joint is 26 mm. The other thing is that I seem to have damaged the boot for the steering knuckle by using a pickle fork.
Disconnect the caliper and mount, and hang it aside. Unbolt the 5 or 6, 6mm allen head bolts from the hub. Pull the hub out and remove the snap ring and washers behind it. Loosen the upper ball joint nut a little and break the joint free. Support the lower control arm with a jack and loosen the lower ball joint nut and break it loose also.
Replacing a Lower Control Arm Ball Joint. Learn how to replace a lower ball joint by pressing it out of the control arm and pressing the new one back in. To watch the longer, in depth version, click the link below. Press out a Ball Joint (In-depth):
How do you put a new ball joint in a car?
Slide the new rubber boot over the ball joint’s stud and guide the new ball joint back up through the steering knuckle hole, where it came from. Bolt the joint into place using the hardware included.
How to replace a steering knuckle hole in a soccer ball?
Guide the new joint through the knuckle hole. Slide the new rubber boot over the ball joint’s stud and guide the new ball joint back up through the steering knuckle hole, where it came from. 2 Bolt the joint into place using the hardware included.