How do you remove brake nuts from Aztek?
Place the jack stands under the frame of the Aztek and lower it down onto the stands. Use the tire iron to fully remove the applicable lug nuts and wheels. Remove the bolts that hold the brake caliper and housing in place, using the wrench and socket set.
How do you change brake pads on an Aztek?
Changing the brake pads is a relatively easy task for anyone mechanically inclined; the task can be completed in a Saturday afternoon by anyone with the right tools. Park the Aztek on a flat and solid surface, preferably on a cement garage floor. Use the tire iron to loosen the lug nuts on the wheels where the brakes will be replaced.
What kind of brakes did the Pontiac Aztek use?
The Pontiac Aztek was a vehicle made by General Motors Corp during the early part of the decade. The Aztek made use of a 4-wheel disc brake system to get the stopping power it needed. The brake pads, which are vital components to this system, need to be changed regularly, as they wear out during usage.
What should I do if my brake caliper is stuck?
Check the rubber boots and remove, clean, and lubricate the guide pins again. They can be a pain to remove when they have been stuck for a while – so a torch is a must to warm them up when trying to remove them. If your sticking caliper problem comes from the vehicle’s rear, there is a big chance of a problem with the parking brake.
The Pontiac Aztek was a vehicle made by General Motors Corp during the early part of the decade. The Aztek made use of a 4-wheel disc brake system to get the stopping power it needed. The brake pads, which are vital components to this system, need to be changed regularly, as they wear out during usage.
Changing the brake pads is a relatively easy task for anyone mechanically inclined; the task can be completed in a Saturday afternoon by anyone with the right tools. Park the Aztek on a flat and solid surface, preferably on a cement garage floor. Use the tire iron to loosen the lug nuts on the wheels where the brakes will be replaced.
Place the jack stands under the frame of the Aztek and lower it down onto the stands. Use the tire iron to fully remove the applicable lug nuts and wheels. Remove the bolts that hold the brake caliper and housing in place, using the wrench and socket set.
How do you replace a brake caliper on a car?
Remove the wooden block and C-clamp from the brake caliper, then place it over the brake pads. Insert and tighten the bolts, using the wrench and sockets. The bolts must be as tight as possible, otherwise they could work their way out and allow the brakes to fall off the wheel. Replace the tire and lug nuts.