How do you remove an antenna from a car?
10.1) Remove trim panel over antenna mast. 11.1) With small wrench, loosen antenna mast. 12.1) Unscrew antenna mast to remove. 13.1) Use socket wrench to remove three mounting screws on antenna mast base. 14.1) Lift hood of vehicle and locate antenna bass and coax cable.
What’s the best way to replace an antenna?
Disconnect the antenna cable from the extension cable. Tie a long wire to the antenna cable. From outside of the vehicle, pull the antenna base and cable assembly until the wire can be easily accessible.
How to remove trim panel from antenna mast?
6.1) At antenna mast, pry edge of small trim panel surrounding antenna mast releasing clip. All clips release with pry pressure. 7.1) Continue prying across top of trim panel releasing clips. 8.1) Pry edge of trim panel releasing clip. 9.1) Lift trim panel from vehicle. 10.1) Remove trim panel over antenna mast.
How do you replace the radio on a caravan?
Remove cup holder. Remove trim panel above cupholder by pulling straight out. Remove center instrument panel trim panel. Remove screws holding radio to instrument panel. Pull radio rearward to gain access to the back of radio ( RADIO ).
Remove the assembly by pulling the antenna mast down through the fender. Uncover the device’s guts by extracting the cover screws. Carefully remove the housing and gear cover, as the nylon cord within might spring out and fling smaller parts.
What causes a car radio antenna to stop working?
As the motor turns the gears, the rigid rope is pushed or pulled and the mast advances or retracts, stopping based on either a digital counter or timer or on a measured spike in voltage when the motor can’t turn anymore. As you might imagine, there are several ways these antennas malfunction.
Can a used car have a radio antenna?
New cars don’t really come with the old-fashioned telescoping radio antenna, but plenty of used cars still have them—and plenty of them are broken.
Where is the antenna on the front of the car?
Front-fender units may be inside the engine bay or behind the inner fender. You’ll likely need a few screwdrivers and wrenches. The mechanism is usually easy to remove—loosen any bolts and disconnect the ground strap, antenna signal wire, and motor-control wires. Be careful with the connectors because they will be reused.