How do you remove a split pin?
Set the convex end of the pin punch into the end of the roll pin. If the roll pin is damaged or has been snapped in half, do your best to align the pin punch so it won’t slip off of the pin as you hammer it. Then, give the end of the punch 2–3 gentle taps with a hammer to loosen it up in its housing.
How important is a cotter pin?
Why Should You Use A Cotter Pin Cotter pins are used in many different installations. They can act as a quick locking mechanism that is easy to remove and replace but their main benefit is that they will prevent a nut from coming loose due to vibrations of any kind.
How do you remove the tie rod from a cotter pin?
Use a properly sized ratchet to remove the castle nut. This is the nut that the cotter pin went through. It holds the tie rod end to the steering knuckle. Removing it will allow you to remove the outer tie rod end. Remove the outer tie rod end from the steering knuckle. To do this, you can use a tie rod puller or a ball joint separator.
What to do if your tie rod backs off?
They use a washer that you need to bend in so if the tie rod backs off, the washer acts as a safety. The outer tie rod uses a castle nut with a cotter pin; if you are tightening the nut, do not back it off to put the cotter pin in, always tighten to get it in so the taper between the tie rod and the knuckles steering arm is not loose.
Where are the tie rod ends on a car?
Locate the outer tie rod end. When you remove the wheel, you will be able to see the steering knuckle. There will be a shaft going through this knuckle with a castle nut on the bottom and a round head on top. This is the outer tie rod. Locate the inner tie rod end. Cars often have an inner tie rod end as well.
How do you remove tie rod from steering knuckle?
Use it to pry the shaft out of the steering knuckle. Remove the outer tie rod end from the inner tie rod end. To do this, you will twist the outer tie rod end off of the spindle of the inner tie rod end. Turn it counterclockwise to loosen.
Use a properly sized ratchet to remove the castle nut. This is the nut that the cotter pin went through. It holds the tie rod end to the steering knuckle. Removing it will allow you to remove the outer tie rod end. Remove the outer tie rod end from the steering knuckle. To do this, you can use a tie rod puller or a ball joint separator.
How do you replace the tie rod on a car?
Connect the tie rod end to the steering knuckle. The shaft of the tie rod end will fit down through the knuckle just as the old tie rod end did. You can move the knuckle and the tie rod end as needed to get them to align properly. Tighten the castle nut.
What does the end of a tie rod do?
A tie rod end also aids in aligning the vehicle, and most are threaded on one end to allow for adjustment. Many vehicles use both an inner and outer tie rod. The inner is attached to the steering rack, the outer to the steering knuckle, and the two are threaded together in the middle.
Use it to pry the shaft out of the steering knuckle. Remove the outer tie rod end from the inner tie rod end. To do this, you will twist the outer tie rod end off of the spindle of the inner tie rod end. Turn it counterclockwise to loosen.