How do you remove a plug from a car door?
Disconnecting the door electrical connector Inside the vehicle: use a flat screwdriver to lift the connector holder and free the wire harness plug (left and middle pictures). From the outside: gently move right and left the other part of the door connector while pulling out in order to free it from its seat (right).
How do you replace a car door connector?
Pull the rubber tube out of it’s recess in the door or car body, and push it back until you reveal an electrical connector (try not to tear the rubber). Pull the connector apart: Depress the tab and separate the door connector half from the car body connector half.
What to do if your car door has two tabs?
If your connector appears to have two tabs on it, try pulling the centermost tab out of the connector (it may not come all the way out) and then push in the other tab and pull them apart. Be careful, especially if your car is older.
How do you change the actuator on a BMW door lock?
The re-installation of the new actuator on to the cable is just the reverse. You have to push the latch mechanism all the way down, and then align the cam pins in their slots in the connector and then pull the mechanism up to draw the connector into its recess.
What’s the wiring in a new car door?
Door wiring: Most new vehicles have a lot of wiring in their doors. That wiring is connected to the control computers in the car. In order to prevent the wiring from getting damaged or corroded, manufacturers enshroud the wiring that travels from the car body to the door in a rubber tube.
Pull the rubber tube out of it’s recess in the door or car body, and push it back until you reveal an electrical connector (try not to tear the rubber). Pull the connector apart: Depress the tab and separate the door connector half from the car body connector half.
What are the tools used to remove terminals from Ford connectors?
Terminal Release Tools Rotunda and Electrical Engineering worked together to design 3 new terminal release tools to allow technicians to easily remove terminals from Ford connectors.
If your connector appears to have two tabs on it, try pulling the centermost tab out of the connector (it may not come all the way out) and then push in the other tab and pull them apart. Be careful, especially if your car is older.
Do you need to remove the cluster from a door lock?
Lift the whole panel straight up to clear it of the catch behind the door handle. Note: If your vehicle has electronic door locks, you will need to remove the door lock cluster panel from the door panel. Before removing the door panel, remove the screws attaching the cluster to the panel.