How do you remove a headlight control switch?
We’ll start the removal procedures with the headlight control switch. The first step is to remove the Headlight knob and shaft from the headlight switch unit. Removing the knob and shaft will provide access to the headlight retaining bezel.
How do you remove the headlamp switch on a Thunderbird?
Photo #2 shows the release button for the headlamp switch knob and shaft, Press and hold the release button while pulling and twisting the knob and shaft, this allows the shaft and knob to be pulled out of the switch. Photo #3 shows the Headlight knob and shaft after its been removed.
What kind of tool do I need to remove ignition switch?
Two types of bezel removal tools are pictured in photo #1. Either type works very well. The bezel removal tool has two different size ends. The larger end is for removing the ignition switch bezel; the small end removes the headlamp switch, wiper controls and heater switch.
How do you remove ignition switch from Thunderbird?
The bezel removal tool has two different size ends. The larger end is for removing the ignition switch bezel; the small end removes the headlamp switch, wiper controls and heater switch. The following procedures require going under the dash. Before starting disconnect the battery. Be sure to record the wire color codes and locations.
How do you remove the control knob on a Thunderbird?
Then remove the control knob by loosening the knob set screw; the knob can then be pulled off the shaft. With these items removed insert the small end of the bezel tool (photo #4) over the shaft and engage the bezel nut, turn counter-clockwise to remove.
We’ll start the removal procedures with the headlight control switch. The first step is to remove the Headlight knob and shaft from the headlight switch unit. Removing the knob and shaft will provide access to the headlight retaining bezel.
Photo #2 shows the release button for the headlamp switch knob and shaft, Press and hold the release button while pulling and twisting the knob and shaft, this allows the shaft and knob to be pulled out of the switch. Photo #3 shows the Headlight knob and shaft after its been removed.
Then remove the control knob by loosening the knob set screw; the knob can then be pulled off the shaft. With these items removed insert the small end of the bezel tool (photo #4) over the shaft and engage the bezel nut, turn counter-clockwise to remove.
Two types of bezel removal tools are pictured in photo #1. Either type works very well. The bezel removal tool has two different size ends. The larger end is for removing the ignition switch bezel; the small end removes the headlamp switch, wiper controls and heater switch.
Can a sealed beam headlight bulb be replaced?
If your car has sealed-beam headlights, this won’t help (but that job is super easy, too—any good car repair manual for your make and model will tell you how). If your actual headlight glass needs to be replaced along with the bulb, that’s an easy fix, too, as is replacing a bad tail light or turn signal .
How do you change a head light bulb?
With the wiring out of the way, you should be able to pull the bulb out by holding onto the base (the part that the plug was in). In some cases, you may have to rotate the bulb slightly for it to release or gently wiggle it to loosen it. Before you take the new bulb out of the packaging, grab a tissue or a clean rag.