How do you remove a door control module?
The module itself is removed by pinching two tabs at the top. So the module is out, and if you ask anyone at Mercedes Benz if there are any internals that can be fixed, they will tell you the door control module is “unserviceable.”
Why are my door locks on my ML 500 not working?
Both of the door locks on the right side of my ML 500 are not working properly. They bounce up and down but do not lock. Here is a video of what they do:
Is the Mercedes Benz door control module unserviceable?
So the module is out, and if you ask anyone at Mercedes Benz if there are any internals that can be fixed, they will tell you the door control module is “unserviceable.” I know remanufactured units use the core of old units, so with my curiosity in full swing, I decided to open the unit up.
What do I need to repair a Mercedes door lock?
2. You will need a torx driver with at least a 4 inch shaft to get to the torx screw for the door handle removal. 3. Buy a set of nylon trim and molding removal tools. It will help get the panels off without scratching the panels or the paint.
Both of the door locks on the right side of my ML 500 are not working properly. They bounce up and down but do not lock. Here is a video of what they do:
How to remove the door panel on a Mercedes?
You will need a set of Torx sockets. To remove the door panel, you will need your screwdrivers, trim plastic wedge but also must have Torx Bit Socket Set if you need to take any other componenet off the door. Using a plastic wedge pull out the outside mirror plastic cover. It is held in place with clips, no screws need to be removed.
2. You will need a torx driver with at least a 4 inch shaft to get to the torx screw for the door handle removal. 3. Buy a set of nylon trim and molding removal tools. It will help get the panels off without scratching the panels or the paint.
How long does it take to take a Mercedes door handle off?
Took me about 3 hours to figure out how to take the door apart the first time. Took me less than an hour to reassemble. Note you will need at least a 4 inch long T20 and T15 torx driver to take off the outside door handle. I have all of the MB instructions at home.