How do you remove a distributor from an engine?
Loosen the bolt or bolts holding the clamp plate to the engine. Undo the pinch bolt and carefully withdraw the distributor. If the distributor is tight, insert a screwdriver blade between the open ends of the clamp plate and prise them slightly apart.
What should I do when replacing my distributor?
Assuming you are replacing the distributor, take out the hold-down clamp that keeps it in place. Some of these are hard to see, but locate it and remove the clamp and hardware. There’s no reason to mark the old distributor since it won’t be going back in. Now compare the new (or rebuilt) distributor with the old one. Are they identical?
Can a spark plug be removed from a distributor?
Carefully, very carefully. Of course, if the engine has been running perfectly before removal of the distributor, just crank the engine until the rotor lines up with the position on the distributor cap where #1 spark plug wire is located.
How do you remove the cap from a distributor?
Step 5: Remove distributor cap: Once the plug wires have been removed, you’ll be ready to remove the distributor cap. Typically the distributor is held in place by two or three bolts or a few clips on the side of the cap. Locate these bolts or the clips and remove them with a socket, extension and ratchet.
How to remove a distributor from a TDC?
With the engine at TDC on #1 cylinder, remove the distributor cap, and disconnect all wires plugged into the distributor. At this point you are going to make three marks.
What’s the best way to reinstall a distributor?
To reinstall, drop the distributor body down into the hole loosely, and line up the two marks for the distributor body and the intake manifold. Then spin the rotor until it points at the mark you made AFTER removal. If you weren’t able to make that mark, position the rotor about 1″ away from the first mark you made.
How can I tell if a distributor has been replaced?
Assuming you are replacing the distributor, take out the hold-down clamp that keeps it in place. Some of these are hard to see, but locate it and remove the clamp and hardware. There’s no reason to mark the old distributor since it won’t be going back in. Now compare the new (or rebuilt) distributor with the old one.
Loosen the bolt or bolts holding the clamp plate to the engine. Undo the pinch bolt and carefully withdraw the distributor. If the distributor is tight, insert a screwdriver blade between the open ends of the clamp plate and prise them slightly apart.