How do you remove a CV axle from a car?
Place a pry bar in between the transmission housing and the CV axle bearing, and pry the CV axle free from the transmission gently. This process works only on the driver’s or left side of the vehicle. If you are working on the passenger or right side of the vehicle, remove the three CV axle mounting bolts from the axle bearing bracket.
Do you need a cotter pin to remove a CV axle?
To do this you must undo the lower ball joint allowing the room for the axle removal. The ball joint nut may or may not have a cotter pin that must be removed to disconnect the ball joint. A ball joint nut that does not have a cotter pin is self locking which will hold itself in place so a cotter pin is not needed.
What’s the best way to replace an axle?
Use a pair of side cutters (dikes) to remove the cotter pin from the axle snout. There might also be a star wheel which can be removed after the cotter pin. 2. Remove the Axle Nut There are three methods that can be used to loosen and remove the axle nut. The first way is what is shown by using an impact wrench which just happens to be the easiest.
How do you remove axle from ball joint?
To do this you must undo the lower ball joint allowing the room for the axle removal. The ball joint nut may or may not have a cotter pin that must be removed to disconnect the ball joint.
When does a CV axle need to be replaced?
Usually, the CV axle will need to be replaced if it is damaged enough to cause vibrations. CV axles serve as the final link between the engine and the wheels. They serve the important function of transferring the torque from the drivetrain to the vehicle’s wheels in order to move the vehicle.
How do you remove a stuck CV axle?
(Spray tie rod, upper ball joint, CV acle shaft nuts with PB blaster, let soak for 5 minutes.) Then place jack under the control arm of same side. Remove the caliper and rotor. Use bungy cord to hold to frame in place so it doesnt fall later. Then remove nut and pull tie rod out of socket and move it out of the way. (Same as tie rod removal).
How do you replace a CV boot?
How To Replace CV Boots: (Applies to most Nissans except the Quest) The simple gist of it: Put the front end of the car up on jack stands. Remove the left front wheel. Remove the retainer pin for the center hub nut. Remove the center hub nut (BIG breaker bar and 32 or 36 mm socket, car in park, 2nd person standing on the brake pedal).
What is a CV axle shaft?
A CV joint axle, which is often known as a half shaft, typically consists of an axle with a constant velocity joint at each end.