How do you read an alignment degree?
By Number. Inside or beside the colors, there are numbers that are measured in degrees to indicate the variances in the angle of measurement. For example, a negative number identifies when there is not enough angle in camber, caster, or toe while a positive number indicates when there is too much angle.
What is the most important alignment angle?
Toe is the most critical tire-wearing angle. Tires that “toe-in” point toward one another. Tires that “toe-out” point away from each other.
What do numbers on alignment mean?
Next to or within the color, you’ll see numbers, measured in degrees that indicate whether there is too much or too little to the angle in the measurement. A positive number for example, means that the wheel has too much camber, caster, or toe.
What are the alignment specifications for a Mercedes Benz?
For alignment specifications, the caster should be 5.96 degrees with a margin of error of 0.50 degrees. The camber in the front should be -1.27 degrees with a margin of error of 0.33 degrees. In the rear, the camber should be -1.25 degrees with a margin of error of 0.50 degrees.
What’s the toe in inches on a Honda AP1?
The Honda AP1 S2000 Shop Manual calls for 0.25 inch of total toe-in at the rear wheels. Toe-in in inches is the difference between measurements A and B in the diagram below.
What are the alignment specifications for a Mercedes SLK 230?
SLK 230 Specifications. For the 2000 SLK 230 Mercedes Benz model, the wheelbase is 94.5 inches. The tread width of the front is 58.5 inches, and in the rear it is 58.5 inches. For alignment specifications, the caster should be 5.96 degrees with a margin of error of 0.50 degrees.
What are the specifications for quickspecs wheel alignment?
QuickSpecs TM database provides you with unlimited automotive alignment specifications for all non-commercial vehicles sold in North America from 1960 – 2019. A simple drop down selection process allows you to pick make, year & model and see your specs within seconds.
How do you check the wheel alignment on a Honda?
1. Remove the wheel cap, and install the wheel alignment gauge attachment (A) and camber/caster gauge on the wheel hub. 2. Read the camber angle on the gauge with the bubble at the center of the gauge. If the camber angle is not within the specification, check for bent or damaged suspension components. Rear camber angle: -1°00¢± 1°
What kind of wheel alignment does a Honda Accord have?
Honda Accord Wheel Alignment Specifications, Suspension Adjustability Information, and Recommended Alignment Type. 1976-1981 Accord The First Generation Accord has a MacPherson strut front suspension. Only Toe adjustablility is provided from the factory, however, aftermarket adjustment methods for Camber and Caster are likely available.
What should the camber angle be on a Honda Accord?
The camber angle can be adjusted up to 1° 40¢(center of tolerance) by replacing both upper and lower damper pinch bolts with the adjusting bolts. However, adjustment is the maximum difference between the right and left side within 2°20¢.
What should the caster angle be on a Honda?
Turn the front wheel 20° outward, then turn the adjusting screw of the camber/caster gauge to set the bubble at 0°. 4. Turn the wheel 20° inward and read the caster on the gauge with the bubble at the center of the gauge. If the caster angle is not within the specification, check for bent or damaged suspension components. Front Caster angle: