How do you program a stay zone on a DSC alarm?
To program your zone definitions, you must:
- Enter Programming by pressing ” * 8 + Installer Code “
- Enter Section 001 (Section 001 is used for Zones 1 – 16 only…
- Now you will enter Zone 1’s 2-digit definition.
- The system will triple beep, and now you will enter zone 2’s definition.
How do I reset my DSC alarm system?
Certain sensors, after having detected an alarm condition, require a reset to exit the alarm condition (i.e. glass break sensors, smoke detectors, etc.). To reset the detectors, press and hold the Reset key for two seconds or press *72. How to set the date and time on the keypad.
Why is my DSC alarm system beeping?
That infernal beeping is likely happening because your alarm panel has detected one or more trouble conditions. Some common beep-inducing issues include low battery indications, battery failure, phone line failure, and communication issues.
What do you need to know about DSC security?
Your DSC Security System has been designed to provide you with the greatest possible flexibility and convenience. Read this manual carefully and have your installer instruct you on your system’s opera- tion and on which features have been implemented in your system. All users of this system should be equally instructed in its use.
Where is the LCD keypad on a DSc?
The LCD keypad has an alphanumeric liquid crystal display (LCD). The keypad is used to send commands to the system and to display the current system status. The keypad(s) will be mounted in a convenient location inside the protected premises close to the entry/ exit door(s).
Where can I use a pc1616 alarm system?
WARNING: This equipment, PC1616/1832/1864 Alarm System shall be installed and used within an environment that provides the pollution degree max 2 and over-voltages category II non-hazardous locations, indoor only.
What should I do with my alarm controller?
REGULAR MAINTENANCE AND TROUBLESHOOTING Keep your Alarm Controller in optimal condition by following all the instructions that are included within this manual and/or marked on the product. CLEANING †Clean the units by wiping with a damp cloth only.