How do you open the hood on a 1999 Honda Civic with a broken cable?
It is visible by looking through the vehicle’s front grille, just above the Honda emblem. The hood release cable attaches to the far right side of the hood release lever. Insert a flat-head screwdriver into the grille and pry the hood latch release lever to the right until the hood releases.
Where is the hood release cable on a Honda Civic?
Maybe you can gain access to it, then strip back the outer shield to the cable to then yank the inner cable. The hood release mechanism in a Honda Civic is located behind the vehicle’s front grille. A hood release cable runs from this mechanism to the hood release lever inside the vehicle.
Can a hood latch on a Honda Civic be replaced?
But over some time, the hood latch on your Civic may give out and will not be able to engage or disengage. Replacing it will require some basic tools and a new hood release cable. So here are the steps you can follow to do so.
What should I do if the cable on my Hood is broken?
There should be a spring lever in the indent next to the headlight. Use a coat hanger or similiar tool to catch the release cables and trigger the cable. There is normally a 1/2 inch loop at the end of the releae cable that either needs to be pushed or pulled to release the hood. HUMAN SPEAKERS: Hood Cable Broken?
What to do if your Honda Hood is stuck?
If the cable has come out of the handle, use a pair of vice grips to pull on the cable and open the hood. The hood release cable can get stuck; the latch may be worn out or misaligned. To open the hood on your Honda, you can try the following procedures. Push down on the hood where the hood latch is located and hold the hood down.
The hood release mechanism in a Honda Civic is located behind the vehicle’s front grille. A hood release cable runs from this mechanism to the hood release lever inside the vehicle. When this cable breaks, you can’t open the hood using the hood release lever.
But over some time, the hood latch on your Civic may give out and will not be able to engage or disengage. Replacing it will require some basic tools and a new hood release cable. So here are the steps you can follow to do so.
How do you remove the hood from a Honda Accord?
Figure 2. Reach under the bumper grille to access the four Phillips screws. Use a 10mm socket, ratchet and extension to remove the three bolts securing the hood latch to the frame. Then, remove the latch and disengage the hood release cable.