How do you make a fork spring compressor?
Place the spring compressor on the fork. You will need a tie-down looped under the vise with each end hooked over the PVC coupler and the threaded rod. Make sure the ends of the tie-down are over the threaded rod from opposite sides. Now start pulling on the tie-down strap and it will begin to compress the fork.
Which way do fork seals go?
The critical direction is the wiper lips on the inside, the square edge needs to face the oil, the tapered edge faces away. You can install the seal either way, but if it is upside down you’ll leak oil.
Can you replace the fork seals on a Suzuki GSX-R1000?
To replace the fork seals on your Suzuki GSX-R1000, you’re going to have to remove the front wheel, front brake caliper assemblies, front fender and the forks themselves. If playback doesn’t begin shortly, try restarting your device. Your browser does not currently recognize any of the video formats available.
How to adjust oil level on Suzuki front fork?
Hold the front fork vertically and adjust the oil level using the special tool. Apply fork oil to the o-ring (13). use new o-ring to prevent oil leakage.
What to do about oil leak on Suzuki GSX-R?
Cover the inner tube with a plastic film. Install the following parts to the inner tube. scratches on the oil seal lip may cause oil leakage. When installing the seals, place a plastic film over the slide bushing groove and edges of the inner tube to avoid damaging the seals’ lip.
Why is my Suzuki GSX are 1000 not working?
Detected condition and possible cause Detected condition Possible cause C15 Output voltage is not with in the following range. 0.15 V ≤ Sensor voltage < 4.85 V Ect sensor circuit open or short. Ect sensor malfunction. Ec …
How to oil a Suzuki GSX-R 1000 front fork?
Pour specified fork oil up to the top of the rod guide case. Push the front fork cap, then stroke the outer tube several times to pump out air. take extreme attention to pump out the air completely. Hold the front fork vertically and adjust the oil level using the special tool.
How to tighten front brake calipers on Suzuki GSX are 1000?
Tightening torque front brake caliper mounting bolt (a): 39 n·m ( 3.9 Kgf-m, 28.0 Lbf-ft) the brake calipers, pump the brake lever until the pistons push the pads correctly. Hold the front axle with the special tool and tighten the front axle bolt (3) to the specified torque.
Hold the front fork vertically and adjust the oil level using the special tool. Apply fork oil to the o-ring (13). use new o-ring to prevent oil leakage.
How big is the front axle on a Suzuki GSX-R?
Brake disc bolt Brake caliper mounting bolt Front axle bolt Front axle pinch bolt Clearance 18 N·m (1.8 Kgf-m, 13.0 Lbf-ft) 39 N·m (3.9 Kgf-m Refer to “front wheel assembly removal and installation” .