How do you install a new speedometer cable?
In any case, take the old cable to the parts store to make sure that the new one is identical. It is a good idea to buy a new gearbox oil seal at the same time. Push the top end of the new cable through the bulkhead. Use a thin screwdriver to ease the grommet into place. Refit the cable into its guide clips.
Can a speedometer be swapped with a gauge?
Otherwise, you may turn the relatively easy gauge swap into a much more difficult electrical problem that requires a professional. There will likely be additional screws on the back of the instrument panel that hold the speedometer in place.
Where is the speedometer located on a car?
The speedometer cable is located on top of the transmission, and it sends an electrical signal into the computer of the car.
How is the speedometer cable connected to the gearbox?
There should be no bend within 50mm of either end. Bends elsewhere should have a radius of not less than 150mm. On some cars, guide clips hold the cable in place. Make sure that it has not worked loose. The cable is connected to the gearbox by a knurled thimble nut, a circlip, or a forked plate .
How to install an electric speedometer in a car?
1. 8Mount speedometer in a 33/ ” dia. hole. Be careful not to cut the hole too large. 2. 8Cut a 3/ ” dia. hole in the firewall for the speedometer wires. Place a rubber grommet in the hole and route the wires through the grommet to the engine compartment. 3. Connect the speedometer wires as shown in the wiring sections. 4.
How do you replace a speedometer cable on a Harley Davidson?
It is pretty easy to replace a speedo cable on your make/model m/c. Remove your dash. Look under your speedo head. You will be able to see where your cable screws onto your speedo. A stock speedo is held onto the dash plate with 2 E clips. Carefully remove those clips with a needle nose pliers.
Can a negative battery be removed from a speedometer?
The negative battery cable should be removed so there is no chance of electrical damage when working with the speedometer. Loosen the battery cable bolt and remove the negative battery cable. Set the cable aside so it can not touch the battery. Step 2: Remove the instrument cluster. Locate the screws holding the instrument cluster in place.
How do you remove the cable from a Speedo?
You will be able to see where your cable screws onto your speedo. A stock speedo is held onto the dash plate with 2 E clips. Carefully remove those clips with a needle nose pliers. Now you can pull upwards on the speedo head and unscrew the cable with a pliers. Once the cable is free, you will be able to slide it down through the frame of your m/c.