How do you fix a sunroof on a 2008 Honda Accord?

How do you fix a sunroof on a 2008 Honda Accord?

Try resetting the moonroof control unit.

1. Close driver’s door, leave it closed during the whole procedure.
2. Turn ignition to LOCK (0).
3. Press and hold the tilt switch, and turn ignition to ON (II).
4. Release the tilt switch, and turn ignition to LOCK (0).
5. Repeat steps 3 and 4 four times.

How do you close the sunroof on a 2006 Honda Accord?

To close:

1. Insert the key in the driver’s door lock.
2. Turn the key counterclockwise, then release it.
3. Turn the key counterclockwise again, and hold it. Both windows and the moonroof start to close.
4. To close the windows and the moonroof further, turn and hold the key again (within 10 seconds of step 2).

How do you open the sunroof on a 2005 Honda Accord?

The sunroof button on the Accord is located on the left side of the dash. To be more specific, it can be found to the left of the steering wheel. You will see a button with a car with a lifted sunroof, that is the button You need to open and close Your sunroof. It is very easy to use as well.

How does the moonroof work on a Honda Accord?

The AUTO OPEN/CLOSE worked, but after the moonroof stopped closing the rear of the roof would either be tilted slight up (about 1/4″) or too low (about 1/8″). It was getting worse over time where it would close, then tilt up about 1/2″ whereby the rubber seal would expose a gap large enough for water to enter into the cabin.

How do I reset the moonroof control unit?

If AUTO functions have been cleared, go to step 7. Press and hold the moonroof close switch until the moonroof is titled fully opened. Confirm that the moonroof control unit is reset by using the moonroof AUTO OPEN and AUTO CLOSE function. Thank you for sharing.

How do you turn off the engine on a Honda Accord?

Turn ignition to LOCK (0), or press the engine start/stop button to select the OFF mode. Press and hold the tilt switch, and turn ignition to ON (II), or press the engine start/stop button to select the ON mode. Release the tilt switch, and turn ignition to LOCK (0), or press the engine start/stop button to select the OFF mode.

The AUTO OPEN/CLOSE worked, but after the moonroof stopped closing the rear of the roof would either be tilted slight up (about 1/4″) or too low (about 1/8″). It was getting worse over time where it would close, then tilt up about 1/2″ whereby the rubber seal would expose a gap large enough for water to enter into the cabin.

If AUTO functions have been cleared, go to step 7. Press and hold the moonroof close switch until the moonroof is titled fully opened. Confirm that the moonroof control unit is reset by using the moonroof AUTO OPEN and AUTO CLOSE function. Thank you for sharing.

Turn ignition to LOCK (0), or press the engine start/stop button to select the OFF mode. Press and hold the tilt switch, and turn ignition to ON (II), or press the engine start/stop button to select the ON mode. Release the tilt switch, and turn ignition to LOCK (0), or press the engine start/stop button to select the OFF mode.