How do you change the shift light on a Autometer tach?
Push and hold red button. Pointer will display the tachometer’s shift- point and the Shift Lite will activate. 2. To set your desired shift-point, continue depressing the red button, then push and turn the Shift-Set knob until the pointer reaches the desired RPM.
How does a tachometer work in a car?
Apply power to the tachometer by attaching the power input wire of the tachometer to the 12-volt dashboard lighting supply of the car. Provide power to the tachometer backlighting. Locate the 12-volt switched dash lighting supply for the dashboard on the car fuse box. Attach the tachometer backlighting wire.
What should the output switch be on a tachometer?
Most of the time, both switches should be down for a 4 cylinder engine, while both should be up for an 8 cylinder. In a 6 cylinder engine, most of the time the 2 switch should be up and the 1 should be down. If you get a new tachometer, read the instructions to be sure. Locate the output wire from your distributor.
How do you mount a tachometer on a steering column?
Bracket mount the tachometer on the steering column. Fabricate or find a secure mounting bracket that will support the tachometer mounting points. Attach the bracket to the steering column. A simple U bracket would suffice for this. Install the tachometer.
Where do I find the pulse wire for a tachometer?
If you get a new tachometer, read the instructions to be sure. Locate the output wire from your distributor. Depending on your engine, there may be a constant-flow wire and a pulse wire to the tach, as well as the additional wires for the ignition, lights, and other components.
Where do you plug shift light into tachometer?
For external Shift-Lite models, plug shift light into tachometer connector. Plug 7is directional, do not force fit! 5) Recommended placement of external Shift-Lite (if applicable) is at 10 o’clock position. it is possible to place Shift-Lite in other positions in accordance with driver preference and 6)vehicle 5)mounting requirements.
How to install a 5 ” auto tachometer?
INSTALLATION INSTRUCTIONS 5″ Tachometer Part Number P5155500 P5155975 INTRODUCTION • Any Auto Meter Shift-Lite™, or Quick-Lite™ Shift-Lite can be used with tachs equipped with a black, Shift-Lite connector. NOTE 1: This tachometer has an air core meter. With power off, it is normal for the pointer to leave zero. When 12V power is applied,
Is it safe to set shift point on tachometer?
Check with engine builder for maximum recommended safe shift point before setting shift point on tachometer. Failure to do this could lead to over-revving of engine, causing serious damage to engine and car. This tach has an air core meter movement. The tach pointer may not always rest at zero. This is normal.
Bracket mount the tachometer on the steering column. Fabricate or find a secure mounting bracket that will support the tachometer mounting points. Attach the bracket to the steering column. A simple U bracket would suffice for this. Install the tachometer.