How do you change the lights on the instrument panel?
Slide the instrument panel forward. Remove the power connectors from the back of the instrument panel, and rotate the panel around. Remove the small lights that need to be changed by rotating them counterclockwise by hand and pulling them out the back of the instrument panel. Insert the new bulbs and reassemble the dash.
Where do you change the lights on a Jeep Cherokee?
The instrument panel lights on your Jeep Cherokee are small, low-wattage bulbs that illuminate the instrument panel from behind. Occasionally these lights burn out and must be replaced. You will typically purchase replacement lights from a Chrysler dealership, although some auto parts stores may carry the correct size bulbs you need.
How do you replace a running light module?
Step 1: Mount the new module in position. Step 2: Connect the electrical connector (s). Connect the electrical connector (s) by pushing them into position until they click into place. Step 3: Bolt the module into place. Bolt the module to the vehicle using the appropriate size wrench or ratchet and socket.
Where do you change the third brake light?
If you are changing the bulb in your pickup truck’s third brake light, it may have to be done from outside the cab, depending on your truck’s make and model. Climb into the cargo bed to remove the lamp housing at the rear of the cab at the top. Do so by turning out the holding screws in a counterclockwise direction with a Philips screwdriver.
How do you change the light bulb on a Dodge Ram?
Push in the new bulb and turn until it sticks. Push the bulb harness into the back of the gauge cluster. Push in and twist until it sticks. Position the gauge cluster back on the dash. Start both screws before you tighten them with the Phillips screwdriver. Tighten the cluster with the Phillips screwdriver.
How to change the turn signal on a Dodge Ram?
Refer to the inside sticker of the fuse box panel and locate the two flasher relays. Switch the relays, and check if the turn signal lights are flashing. If one or both of the relays fails to turn on the turn signal light, replace as needed.
Where is the brake light switch on a Dodge Ram?
Dodge Ram turn signal lever. The brake light switch can wear out, which translates into no brake lights on your Dodge Ram. If the bulbs as well as the connections are good and the wires are properly grounded, replace the switch. You will find it under the brake pedal. Figure 4. Brake light switch.
Why are my dash lights not working in my Dodge Ram?
Removing and replacing the dash lights in your Dodge Ram will improve visibility of your gauges when you are driving at night. The dash lights and the light colors of the gauges will make your cluster light up and help improve overall safety of your truck. Pull the decorative trim off around the gauge cluster.