How do you change the lights on a Jeep Grand Cherokee?
Pull down on the upper cluster mounting tabs and pull the cluster out far enough to access the electrical connector on the rear of the cluster. Unplug the connector and pull the cluster out. Locate the bulbs that you need to change on the rear of the cluster.
How do you change the instrument panel on a Jeep Cherokee?
Use the screwdriver to twist out the two screws on the underside of the Cherokee’s cowl on the instrument panel. Pull the cowl forward by hand, and remove the cowl trim. Remove the four screws holding the instrument panel in place. Slide the instrument panel forward.
How do you change the lights on the instrument panel?
Slide the instrument panel forward. Remove the power connectors from the back of the instrument panel, and rotate the panel around. Remove the small lights that need to be changed by rotating them counterclockwise by hand and pulling them out the back of the instrument panel. Insert the new bulbs and reassemble the dash.
How do you change the battery on a Jeep Cherokee?
Open the hood of the Jeep Cherokee, and disconnect the negative battery cable. Loosen the nut on the cable clamp, using a socket wrench, and slide the clamp off the negative terminal. Use the screwdriver to twist out the two screws on the underside of the Cherokee’s cowl on the instrument panel.
Where do you change the lights on a Jeep Cherokee?
The instrument panel lights on your Jeep Cherokee are small, low-wattage bulbs that illuminate the instrument panel from behind. Occasionally these lights burn out and must be replaced. You will typically purchase replacement lights from a Chrysler dealership, although some auto parts stores may carry the correct size bulbs you need.
Use the screwdriver to twist out the two screws on the underside of the Cherokee’s cowl on the instrument panel. Pull the cowl forward by hand, and remove the cowl trim. Remove the four screws holding the instrument panel in place. Slide the instrument panel forward.
Slide the instrument panel forward. Remove the power connectors from the back of the instrument panel, and rotate the panel around. Remove the small lights that need to be changed by rotating them counterclockwise by hand and pulling them out the back of the instrument panel. Insert the new bulbs and reassemble the dash.
How do you change the light on the dashboard?
Start with locating the dimmer switch for the dashboard lights. Tip: If you are having difficulty locating it, refer to your vehicle’s owner manual. Step 2: Adjust the dimmer switch. After locating the dimmer switch, turn the key to the second position and turn on the headlights. Press the switch and see if the dashboard lights become brighter.