How do you change the gear on a manual?
I slid a butter knife under the trim and worked it out that way. Once you have the panel detached from the rest of the dashboard, you simply unscrew the gear knob and pull the gaiter (still attached to the panel) up off the gear lever. Finally pull the chromed piece of trim surround away from the panel.
How to replace the gear shift gaiter on a manual transmission?
I have a 2007 diesel CR-V with a manual transmission. The gear shift gaiter was worn around the gear lever knob so I decided to replace it with an after-market gaiter made of leather. To change the gaiter you need to remove the air conditioning controls then the panel surrounding the gear lever.
Can a gearbox be taken out of a car?
It is no problem to take out the gearbox from inside the car. You just need to make an arrangement to keep the engine in place. I use a 2×4 across the engine compartment with a hook in the eye on the engine and a long bolt to ajust the height of the engine . But the clutch is not on the gearbox. Only the throw-out bearing.
How to remove a gearbox from a TR6?
You will need to drop the propshaft away from the back of the GB. If you do not remove the propshaft then you will need to drop the exhaust pipe (depending on type) to allow the propshaft to make room. Remove both seats. Remove the righthand side seat slide and carpets. Pull the GB rewards and waggle onto the righthand side.
How do you remove bolts from a gearbox?
Take out the two a-in. B.S.F. bolts from the gearbox cover (above the kickstart bearing) and remove the cover. Hold the gearshaft from turning and unscrew the gearshaft nut that is exposed by the removal of the small cover.
How can I repair my iFixit lightweight gearbox?
Lift off the gearbox end cover. Lift out the gearbox centre web complete with the gear cluster. Retrieve the two selector forks from the gear cluster (otherwise they’ll fall off). Retrieve the detent plunger and spring from the main casing (otherwise it will fall out later). The budget option, covered by our Lifetime Warranty.
How do you put a 4th gear in a transmission?
The protrusion of 4th gear lay fits against this inner race. Squirt some of the 90w gear oil you are going to fill your gearbox with on the two bearings in the gearbox shell. Fill a small tub with gear oil, so you can dip each gear and bushing into it prior to placing into the gearbox.
How do you drain oil out of a gearbox?
Drain out all oil by removing the drain plug from the end cover, (Fig. 15). Take out the two a-in. B.S.F. bolts from the gearbox cover (above the kickstart bearing) and remove the cover. Hold the gearshaft from turning and unscrew the gearshaft nut that is exposed by the removal of the small cover.