How do you change the fuel gauge on a jeep?
Pull the relay panel lid off. Pull out the old fuel sensor relay. If you are unsure of its location, consult the relay diagram on the inside of the relay panel’s lid. Plug the new sensor in and replace the relay panel lid. Replace your Jeep’s negative battery cable.
Where is the fuel sensor relay on a Jeep Cherokee?
Lift your Jeep’s hood and remove the negative battery cable. If your model Jeep has them, unclasp the two clamps that hold the relay panel lid on. Do this by hand. The main relay panel is located near the battery. Pull the relay panel lid off. Pull out the old fuel sensor relay.
How do you replace a fuel rail sensor?
Clean the fuel rail sensor harness with electrical cleaner to remove any debris. Step 8: Install the new fuel rail sensor onto the fuel rail. Screw in the mounting hardware finger tight. Tighten up the mounting hardware to 12 inch pounds then a 1/8 turn. This will secure the fuel rail sensor to the fuel rail.
How to clean the MAF sensor on a Jeep Grand Cherokee?
Remove the Sensor- Take care not to damage the wiring harness or the connector pins that receive the harness in the MAF. Simple hand tools will be all that you need to complete the job. Clean the Sensor – Now that you’ve removed your Grand Cherokee’s MAF sensor, it’s time to clean it.
Pull the relay panel lid off. Pull out the old fuel sensor relay. If you are unsure of its location, consult the relay diagram on the inside of the relay panel’s lid. Plug the new sensor in and replace the relay panel lid. Replace your Jeep’s negative battery cable.
Lift your Jeep’s hood and remove the negative battery cable. If your model Jeep has them, unclasp the two clamps that hold the relay panel lid on. Do this by hand. The main relay panel is located near the battery. Pull the relay panel lid off. Pull out the old fuel sensor relay.
Remove the Sensor- Take care not to damage the wiring harness or the connector pins that receive the harness in the MAF. Simple hand tools will be all that you need to complete the job. Clean the Sensor – Now that you’ve removed your Grand Cherokee’s MAF sensor, it’s time to clean it.
Where is the relay panel on a jeep?
Lift your Jeep’s hood and remove the negative battery cable. If your model Jeep has them, unclasp the two clamps that hold the relay panel lid on. Do this by hand. The main relay panel is located near the battery. Pull the relay panel lid off.