How do you change the brakes on a Mitsubishi Outlander?
Procedure
- Start by putting your Mitsubishi Outlander in the park and setting the emergency brakes.
- Jack up your Mitsubishi Outlander.
- Remove the front wheel from the car.
- Use a flathead screwdriver to put pressure between the old pad and caliper.
- Use a 14mm socket to remove one of the guide pins.
How much does it cost to replace brake pads on a Mitsubishi Outlander?
The average cost to replace the brake pads on a Mitsubishi Outlander is $195-$300 if you are replacing only the brake pads. If you replace the rotors at the same time that price goes up to $450-$600. If you decide to replace your Mitsubishi brake pads and rotors yourself, you will spend $100-$150 on parts.
What are the brake lights on a Mitsubishi Outlander?
The brake lights on your 2016 Mitsubishi Outlander illuminate when you hit the brake pedal and help prevent you from being rear ended by the cars behind you. Brake light bulbs grow dimmer over time and eventually burn out. This video shows you how to change the brake lights on your 2016 Mitsubishi Outlander.
Do you need to change the lights on your Outlander?
If you are going to replace a bulb in your cluster, it is a good idea to replace all of them. Not only will the lights on your Outlander be brighter, you decrease the likelihood you will need to change any of the bulbs again in the near future.
The average cost to replace the brake pads on a Mitsubishi Outlander is $195-$300 if you are replacing only the brake pads. If you replace the rotors at the same time that price goes up to $450-$600. If you decide to replace your Mitsubishi brake pads and rotors yourself, you will spend $100-$150 on parts.
How can I tighten my brake pads on my Outlander?
Tighten the two caliper bolts by turning them counterclockwise (as seen from the outside of the car) to just past hand tight or about 30 lb-ft of torque. Double check that the two caliper bolts are tight before moving on to the next steps.
Where is the wear bar on a 2015 Outlander?
On this 2015 Outlander Sport, the wear indicator bar was located on the bottom of the inner brake pad. If your new set of rear pads includes replacement brake hardware, pull the old metal pad abutment or “anti-rattle” clips out of the top and bottom of the bracket.
How do you replace rear disc brake pads?
If your new set of rear pads includes replacement brake hardware, pull the old metal pad abutment or “anti-rattle” clips out of the top and bottom of the bracket. Apply a thin layer of brake caliper grease to the to new pad abutment clips where they will come in contact with the bracket or the new brake pads.