How do you change a transmission kickdown cable?
Method 1 of 1: Replacing the kickdown cable
- Materials Needed.
- Step 1: Jack up the front of the vehicle and set the jack stands.
- Step 2: Place wheel chocks on the rear wheels.
- Step 3: Disconnect the kickdown cable at the carburetor or throttle body.
- Step 4: Remove the kickdown cable from the mounting bracket.
How does a kickdown cable work?
The kick down cable is mounted to the carburetor, or, in the case of fuel injected vehicles, the throttle body. It runs from the butterfly arm on the carburetor down to the side of the transmission, where it attaches to an arm that allows the transmission to shift gears.
How do you adjust the cable on a 200r4?
Locate the Adjust Tab on the cable housing. Press in the tab and push the slider as shown in Figure 3. b. Release the tab and rotate the throttle lever to WOT and the cable will self adjust itself as evidenced by a few audible clicks.
Is a TV cable the same as a kickdown cable?
“Kickdown” and “TV” cables aren’t really the same thing. Let’s take it from the top: Many old-school automatic transmissions use both a governor and a vacuum modulator to help regulate automatic shift timing. The governor works off of vehicle speed and engine rpm.
How do you install a kickdown cable on a GM Truck?
Leave the kickdown mounting bracket on the kickdown cable adjuster. Remove the inner wire from the cable housing. Step 2:From the engine end of the kickdown cable housing, install the tube hold down clip onto the cable housing with the lip pointed downwards, and slide it down to the trans tube at the end of the cable housing.
What do you need to know about kickdown cable?
Congratulations. With this purchase, you have remedied the age-old problem of chasing the correct throttle pressure linkages, pivots, and brackets from salvage yards or poor imitations of original parts.
How to reinstall throttle cable with kickdown cable?
Push stud back into O.E. throttle bracket hole and reinstall vehicles original throttle cable, reusing O.E. cable clamp and nut. (see Figure 5C) Step 1. With BPE part # 3395]
Is there a kick down cable for upshift?
Kickdown cable is only for kick down. Has nothing to do with upshift. It’s possible it’s not connected in the transmission. If it has an aftermarket modulator valve that is adjustable, you can take a very small screwdriver inserted in the vacuum hole and screw the adjustment in. That should make the shift later.