How do you change a serpentine belt on a Dodge Ram?
How to Replace the Serpentine Belt in a Dodge Ram
- Disconnect the negative battery terminal.
- Locate the serpentine belt tensioner pulley.
- Rotate the tensioner pulley by turning the bolt, either with a wrench for some models or a breaker bar or ratchet for other models.
Can I replace a drive belt myself?
You can replace a serpentine belt with ordinary hand tools. But we don’t recommend it. The spaces are often tight and the belt-driven devices difficult to reach. The belt placement tool allowed us to remove and properly place the new belt without reaching down into the pulley area.
Is the tensioner pulley supposed to move?
Appearance: Cycle the tensioner (mounted on the engine) through the entire range of motion (from stop to stop) by applying torque to the arm with a wrench. The tensioner arm should move smoothly and freely. Solution: If you notice a binding, sticking or grinding tensioner arm, the tensioner should be replaced.
What is a tensioner pulley?
A drive belt tensioner is a pulley mounted on a spring mechanism or adjustable pivot point that is used to keep tension on the engine belts. Both are used to keep tension on the engine serpentine belts so that they can drive the various engine accessories.
How do I know if my idler pulley is bad?
Signs and Symptoms of a Bad Idler Pulley
- Chattering, Squealing, or Chirping Sound.
- Corroded Surface.
- Excessively Loose Idler Pulley.
- A Bad Idler Pulley May Spin Excessively.
- Slow to No Spin or Binding.
How do you replace serpentine belt on Dodge Ram?
Turn the tensioner clockwise as if tightening the bolt to release tension on the belt. While holding the tensioner away from the belt with one hand, slide the loosened belt off of the tensioner pulley.
How do you replace the fan belt on a Dodge Ram 1500?
Examine the way the fan belt is looped around each engine part so that you will remember how to put it back on when you are installing the new belt. Loosen the tension on the fan belt by moving the tensioner pulley with a pry bar or socket wrench. Slip the fan belt off the tensioner pulley and allow the pulley to return to its regular position.
How much does it cost to replace a belt on a Dodge Ram 1500?
The average cost for a Dodge Ram 1500 serpentine belt replacement is between $122 and $136. Labor costs are estimated between $52 and $65 while parts are priced at $70. This range does not include taxes and fees, and does not factor in your specific model year or unique location.
How do you install a new engine belt?
Rotate the tensioner again to allow the new belt to slip onto all pulleys. Check to make sure it is seated right on all pulleys with the ribs in the grooves. Re-connect the battery terminal. Run the engine and observe the belt for proper functioning.