How do you change a drive belt on a Sportster?
How to Replace a Sportster Drive Belt
- Remove the Allen bolts that secure the rear brake caliper to the frame with an Allen wrench.
- Loosen and remove the axle nuts on each side of the axle using wrenches.
- Slide the rear tire forward and remove the drive belt from the rear axle pulley.
How long does a motorcycle belt last?
100,000 miles
But even veteran enthusiasts can make the mistake of forgetting to look after their bike’s drive belt, which is strong, stretch-resistant and made from tensile cords. Because a drive belt can last up to 100,000 miles before needing replacement, riders may lose track of this important part of motorcycle maintenance.
How do you remove drive belt from Sportster?
Slide the rear tire forward and remove the drive belt from the rear axle pulley. Drive the axle out of the rear wheel using a screwdriver and hammer. Pull the rear wheel off the Sportster. Remove the bolts that secure the right shock to the swing arm using a wrench. Push the shock upward and suspend it from the frame using a wire tie.
How do you replace the rear belt on a Harley Davidson?
When Bob and Mark say it, all come near and watch. In this 95-minute video, they show us how to remove and replace the rear belt on the Harley-Davidson Sportster. The final belt can last a long time, mileage wise, but sometimes all it takes is a rock to get stuck in the belt and run through the pulleys a couple times to split it.
Can a chain be replaced on a Sportster?
The process for changing the drive belt on a Sportster differs from the traditional process of replacing a chain. Belt drives offer smoother acceleration and longer lie than older chains, which is why Harley moved away from installing chains and started installing belts on their Sportsters.
Why did Harley Davidson start using belt drive?
Belt drives offer smoother acceleration and longer lie than older chains, which is why Harley moved away from installing chains and started installing belts on their Sportsters.
Slide the rear tire forward and remove the drive belt from the rear axle pulley. Drive the axle out of the rear wheel using a screwdriver and hammer. Pull the rear wheel off the Sportster. Remove the bolts that secure the right shock to the swing arm using a wrench. Push the shock upward and suspend it from the frame using a wire tie.
When Bob and Mark say it, all come near and watch. In this 95-minute video, they show us how to remove and replace the rear belt on the Harley-Davidson Sportster. The final belt can last a long time, mileage wise, but sometimes all it takes is a rock to get stuck in the belt and run through the pulleys a couple times to split it.
The process for changing the drive belt on a Sportster differs from the traditional process of replacing a chain. Belt drives offer smoother acceleration and longer lie than older chains, which is why Harley moved away from installing chains and started installing belts on their Sportsters.
Belt drives offer smoother acceleration and longer lie than older chains, which is why Harley moved away from installing chains and started installing belts on their Sportsters.