How do you calibrate the compass on a 2017 Yukon?
Turn on the electronic vehicle information center (EVIC), and select “System Startup”. Toggle through the EVIC options until you reach “Calibrate Compass”, and select. Press and release the SELECT button to begin the calibration; the CAL indicator should be displayed on the EVIC system.
Why is the compass on my Nav not working?
The compass on the nav screen is not working. The one on the DIC says “CAL” for calibration. The light on my rear view mirror is red instead of green and I can’t contact onstar by pressing the button. You need to calibrate the unit. Read how to in your owners manual. You will need a big open lot to drive in circles. You need to calibrate the unit.
Where is the temp sensor on a GMC Yukon?
There’s actually an on/off button for the temp/compass display on the mirror. It is the button located on the left front of the mirror itself. Push this and the display should turn on. gmc Yukon , Denali, and Tahoe. You can’t post conmments that contain an email address. An expert who has achieved level 1.
Why does my GPS and compass not work?
My compass in the DIC now doesn’t move and reads “–“. On top of that, OnStar is disabled. I pulled into an empty parking area and drove 10 circles counter-clockwise, parked for 3 minutes, drove 10 clockwise circles and neither seemed to help recalibrate the compass or the GPS.
Why is my temp sensor and compass not displaying?
Re: temp sensor and compass not displaying on my 2003… Yes. Look in the Fuse Panel inside the Truck. Use a Good Maglight or LED Flashlight and Hold it Behind the Fuses to see the Blown Ones. It is usually in an AUX Outlet. Also check thr Fuse Relay Box under the Hood for a Blown Fuse using the Same Method.
The compass on the nav screen is not working. The one on the DIC says “CAL” for calibration. The light on my rear view mirror is red instead of green and I can’t contact onstar by pressing the button. You need to calibrate the unit. Read how to in your owners manual. You will need a big open lot to drive in circles. You need to calibrate the unit.
How does the calibration work on a GMC compass?
Press the set/reset button to start the compass calibration. 4. The DIC will display CALIBRATING: DRIVE IN CIRCLES. Drive the vehicle in tight circles at less than 8 km/h (5 mph) to complete the calibration. The DIC will display CALIBRATION COMPLETE for a few seconds when the calibration is complete.
There’s actually an on/off button for the temp/compass display on the mirror. It is the button located on the left front of the mirror itself. Push this and the display should turn on. gmc Yukon , Denali, and Tahoe. You can’t post conmments that contain an email address. An expert who has achieved level 1.
My compass in the DIC now doesn’t move and reads “–“. On top of that, OnStar is disabled. I pulled into an empty parking area and drove 10 circles counter-clockwise, parked for 3 minutes, drove 10 clockwise circles and neither seemed to help recalibrate the compass or the GPS.