How do you bypass Harley Davidson Tssm?
Step 4 – Resetting the TSSM
- Move kill switch to off position, turn ignition on-off-on-off-on.
- Press left turn signal switch twice, pause, and lights will flash.
- Press right turn signal switch once, pause, and lights will flash.
- Press right turn signal switch once, pause, and lights will flash twice.
What is Tssm on Harley Davidson?
This Bulletin covers the TSSM (Turn Signal Security Module) reset procedure for 2001 and new non-canbus Harley-Davidson Models (with alarm) which should be completed when the turn signals are flashing rapidly with the Signal Stabilizer installed correctly.
Where is the Tssm on a Harley?
The TSM / TSSM / HFSM is located in the bottom of the battery tray.
How to diagnose a Harley Davidson TSM / TSSM?
I {Heart} Hookers. To diagnose the TSM/TSSM observe the behavior of the turn signals. 2 Turn Ignition key On-Off-On-Off-On-Off-On and then toggle the Left Turn Signal switch twice. – – 3 Turn Ignition key Off-On Verify the Check Engine lamp and Security Lamp illuminate briefly and then turn off.
Is the TSM the same as the TSSM?
The optional, factory-installed, security system (turn signal security module or TSSM) provides the same functionality as the TSM, but also includes: Security and immobilization functions. See 3.2 TSM/TSSM FEATURES for complete details. TROUBLESHOOTING Problems fall into at least one of four categories: Turn signal malfunction.
Where is the TSM / TSSM / hfsm located in a car?
Disconnect the positive battery cable from the battery and remove the battery. 5). The TSM / TSSM / HFSM is located in the bottom of the battery tray. From under the rear fender and just in front of the rear tire, push the TSM / TSSM/ HFSM up through the battery tray. 6).
Are there any running lights on my TSSM?
None of his signals work, no front no rear. If he plugs in the run-stop module he has running lights on 3 signals. He said he switched bulbs on the one but still no running lite on it. All he really wants to know now is there any way to make sure it is the TSSM. Re: Tssm ? Update Ugh I apologize I did not get all the information correct.
I {Heart} Hookers. To diagnose the TSM/TSSM observe the behavior of the turn signals. 2 Turn Ignition key On-Off-On-Off-On-Off-On and then toggle the Left Turn Signal switch twice. – – 3 Turn Ignition key Off-On Verify the Check Engine lamp and Security Lamp illuminate briefly and then turn off.
The optional, factory-installed, security system (turn signal security module or TSSM) provides the same functionality as the TSM, but also includes: Security and immobilization functions. See 3.2 TSM/TSSM FEATURES for complete details. TROUBLESHOOTING Problems fall into at least one of four categories: Turn signal malfunction.
None of his signals work, no front no rear. If he plugs in the run-stop module he has running lights on 3 signals. He said he switched bulbs on the one but still no running lite on it. All he really wants to know now is there any way to make sure it is the TSSM. Re: Tssm ? Update Ugh I apologize I did not get all the information correct.
How to bypass the turn signal module ( TSM )?
This is the key to bypassing the turn signal module. In order to remove the TSM and get the bike to run…you must allow the starter relay to go to ground (which the TSM normally controls). To do this, you would place a jumper between the start relay control (position #9) and the ground wire (position #12).