How do you adjust a V belt drive?
Most drives have two sheaves, one on the motor and one on the driven machine. The motor base usually has slotted holes to allow for adjustment toward and away from the driven machine. Loosen the motor hold down bolts and move the motor toward the drive machine to the inner end of the adjustment to release tension on the belts.
Where is the power steering drive belt located?
The belt that drives a power-steering hydraulic-fluid pump is usually at the front of the engine , turned by a pulley on the crankshaft . It is generally separate from the belt that drives the water pump and alternator , but it may drive other components as well as the power-steering pump .
Where is the drive belt on a car?
The Video Course teaches you everything about modern cars. The belt that drives a power-steering hydraulic-fluid pump is usually at the front of the engine , turned by a pulley on the crankshaft .
How to get a belt drive and bearing reference guide?
Belt Drives & Bearings Reference Guide nProduct Information nInstallation nPreventative Maintenance nTroubleshooting The First Name in Performance HVAC Belt Drives and Bearing Products Customer Service — U.S. and International Phone 866 869 2075 Fax 800 262 3292 Customer Service — Canada Phone 800 268 4149 Fax 800 668 9005
What’s the best way to clean a drive belt?
We suggest the EPI Belt Bag for this! This new Drive Belt Storage Bag will keep your belt clean and ready to install when you need it, and comes with handy mounting tabs to secure it on your machine. Next, clean the clutch surfaces with a scotchbrite pad or very light sandpaper and then wipe them down with brake cleaner to remove all residue.
What kind of belt do I need for my DDP clutch?
The new belt I installed is the latest part # from Polaris. The belt we used to get out of the woods was a heavy duty polaris belt that I got with my DDP clutch kit. Both of these had the same problem.
Is there a problem with my new belt?
Installed a NEW oem belt and still have the problem. This machine has NEVER had any tendency to creep or had any difficulty shifting. Any experience or insight into this would be appreciated.
Is the factory belt on my 08s too tight?
The 08s factory belt #s have changed a few times, and to be honest the latest batch seem to fit too tight, which is probably why you are having this issue. The good news is if you take it out and run it for an hour or two it should wear in. Thanks carnivore.