How do I update my Dlink DIR-505 firmware?
Step 1: Unplug the DIR-505/505L from the wall outlet, move the selector switch to Router/AP Mode. and plug it back in. Once the router finishes rebooting, the firmware will be upgraded.
How do I reset my DIR-505?
Step 1: While the router is on, use the end of a paper clip to press the button inside the pinhole on the underside of the router, as highlighted by the red circle below. Step 2: Hold the button down for 10 seconds and then release. Step 3: The unit will reboot automatically.
How do I make my Dlink router a repeater?
How to setup Repeater mode on my router? Step 1: Open your Internet browser and enter http://dlinkrouter, http://dlinkrouter.local, or http://192.168.0.1 into the address bar. Step 2: The default username is Admin. Enter your administrator password.
What is Repeater mode?
In Repeater mode, the access point extends the range of an existing Wi-Fi network. This mode is suitable when you are in a Wi-Fi dead-zone or a place with weak wireless signal, and you want to have a larger effective range of the wireless signal throughout your home or office.
Are there different versions of the Dlink 505?
Apparently so far there are four versions of the dlink 505: DIR-505 A1, DIR-505L A1, DIR-505 A2, DIR-505L A2. They differ a bit on the “outer” hardware (switches, power supply stability, plugs), but the main router hardware is the same for all versions .
How to flash a D-Link dir-505 with OpenWrt?
The easiest method to flash a DIR-505 with an OpenWrt factory image is via the D-Link Router Recovery Mode as described in http://forums.dlink.com/index.php?topic=44909.msg162511#msg162511 The essential how to for the D-Link Router Recovery Mode :
How to configure my dir-505 to work as a link?
Step 1: Make sure your computer or mobile device is connected to the DIR-505 by Wi-Fi. Open your web browser and enter http://dlinkrouter or http://dlinkrouter.local into the address bar. Step 2: At the login page, enter the Admin password. If you have not changed the administrator password from the default, leave the field blank. Click Log In.
What does the fourth position on the dir-505l do?
The fourth position is used by the DIR-505L model to shutdown the software and operate as a USB charger – on the DIR-505 the case keeps the switch from going into the fourth position.