How do I Turn on the anti theft light?
The way you do this is first to look at the dash to see if the anti-theft light is on. If it is, then put the key in the ignition and turn it to the on position. This is the position that activates the accessories such as your lights and radio. After doing this, you have to wait ten to fifteen minutes.
Why does my car anti theft system not work?
Check the key. The key itself could be the culprit for the anti theft system car wont start. The keys have a built-in chip that sends a code to the alarm system when you insert it into the ignition. That chip won’t work in case of a broken or damaged key.
Why does my anti theft alarm not go off?
Sometimes though your anti-theft system will engage, the alarm won’t be going off, but you still won’t be able to start your vehicle, and that is because your wheel is locked. This can happen if the steering wheel got bumped too much after turning the car off. When the steering wheel is locked, you also won’t be able to turn the key.
Is there an anti theft light in the trunk?
Use the trunk to first lock the driver door then unlock it. Was this answer helpful? Some anti-theft lights blink by default ( a small red light near the dash, for example is there to warn off thieves ).
Where is the anti theft light on a Ford?
The display of the car behind the steering will light up and will show the anti-theft light blinking or constantly lit. Leave the key in this position for at least 10 minutes. Check the anti-theft light again.
How to reset the anti theft light on it?
Try unhooking the positive battery cable with the switch on.Let unhooked for 15 minutes.Than hook cable back up with the key still on.than shut off and try to start.It worked on my f150. Was this answer helpful? I have 2002 ford explorer how do I reset the anti thief on it ,please
Why is my anti theft system not working?
When the anti-theft system is activated accidentally, most people suspect a faulty key. While this could be a possible reason, it is a bleak one because the keys made by Ford are usually strong and sturdy. So, before you look to get your key replaced or repaired, try these simple steps to reset the anti-theft system of your Ford.
How to reset the anti theft system in a Ford?
1 Insert the key into the ignition and turn it on to the position where the accessories are activated but not the engine. 2 Leave the key in this position for at least 10 minutes. 3 Check the anti-theft light again. 4 Now try to start the engine. 5 Repeat the process at least a couple of times if it does not work the first time.
How to disable anti-theft system in your car in the right?
Insert the key in the door lock all the way and then turn the key to unlock your car door, but don’t release it. You want to hold the key in the unlock position for twenty to thirty seconds. This lets the car recognize that you have the right key and will disengage and reset the system.
How to replace the transponder antenna on a car?
Replacing the transponder antenna isn’t that difficult. Disconnect the negative battery terminal. Then remove the tilt column shaft by twisting it and pulling out. Next remove the three screws from the lower steering shroud on the column.
How do you add a spare key to an ignition?
There is a different procedure to add a spare key. 1. Insert the non programmed key in the ignition and turn to RUN. 2. THEFT indicator flashes rapidly. 3. After 15 minutes of flashing, the THEFT indicator will stop flashing. 4. Within five minutes after the THEFT indicator has stopped flashing, turn the ignition key to OFF and back to RUN. 5.
The way you do this is first to look at the dash to see if the anti-theft light is on. If it is, then put the key in the ignition and turn it to the on position. This is the position that activates the accessories such as your lights and radio. After doing this, you have to wait ten to fifteen minutes.
Insert the key in the door lock all the way and then turn the key to unlock your car door, but don’t release it. You want to hold the key in the unlock position for twenty to thirty seconds. This lets the car recognize that you have the right key and will disengage and reset the system.
Replacing the transponder antenna isn’t that difficult. Disconnect the negative battery terminal. Then remove the tilt column shaft by twisting it and pulling out. Next remove the three screws from the lower steering shroud on the column.
There is a different procedure to add a spare key. 1. Insert the non programmed key in the ignition and turn to RUN. 2. THEFT indicator flashes rapidly. 3. After 15 minutes of flashing, the THEFT indicator will stop flashing. 4. Within five minutes after the THEFT indicator has stopped flashing, turn the ignition key to OFF and back to RUN. 5.
The display of the car behind the steering will light up and will show the anti-theft light blinking or constantly lit. Leave the key in this position for at least 10 minutes. Check the anti-theft light again.
What does the anti-theft light mean on the dash?
Your car comes standard with a handy Anti-theft system called SecuriLock®. When you lock the doors and activate the Anti-theft system, the light will show in the dash. It should flash slowly, which indicates that the system is operating normally. If the light does not flash, then the security system is not armed.
Can a Ford reprogram the anti theft system?
Basically, Ford has you over a barrel. As I understand it, Ford is the only one that has the ability to reprogram the anti theft system. Think about it. That kind of information shouldn’t be public.