How do I turn on my RX-8?

How do I turn on my RX-8?

Starting Procedure

1. With the ignition off, press the accelerator pedal to the floor and hold.
2. Turn key to start the engine, keeping the pedal to the floor.
3. If the engine starts, release pedal to avoid over-revving the engine.
4. If the engine does not start, continue to hold key in the start position for 8 seconds.

Why does my 2004 Mazda RX 8 not start?

“Owner dropped 2004 Mazda RX-8 to the dealer to fix recall, driver and passenger air bag, voluntary emission recall, and also owner complains that the engine won’t start when the engine is hot, you have wait for about 30 minutes to cool down the engine before the engine starts again. Advisor asked the owner to have the engine diagnose.

Why does my Mazda RX8 have low compression?

The problem is that as the rotors wear down, the fuel and air mixture may start to leak from one combustion chamber into another, which reduces the engine’s efficiency. This leads to low compression and manifests itself as poor starting when warm. So the first piece of advice if you insist on buying one – Get a hot compression test done by Mazda.

Why is my Mazda RX8 rotary engine burning oil?

More than not, you will have to check your oil levels, and ensure you’re running a sufficient amount of oil. Perhaps this is the biggest problem with the rotary engine. With this engine you are burning significant amounts of oil, while it is also a challenge to seal off the different chambers.

Can you put ATF in a Mazda RX8?

Yes ATF works good. Yes, do not just start the engine and move car 20 feet and shut off. You need to get the engine warm or hold at 4-5K rpms before shutting off. I put oil in one intake port. could not get the cap off the rear one so I put oil in the lead spark plug holes as the manual said.

Why does my Mazda RX-8 engine not start?

At the time it sounded like the battery, because engine turned very slowly. Since, I’ve changed battery, checked all fuses, and engine still doesn’t start (though it engine turns fine). Would you please assist me with any info which will help me to determine what’s wrong.

What should I do if my Mazda RX-8 stall?

Try puting your car in neutral at the light – the vibration should stop or be barely noticeable. Mazda had a regional rep come out to look at my car, and his solution was to give me my 7th set of motor mounts. The vibration was a little better for about 10 feet, then it was back and worse than ever.

Is there a recall on a Mazda RX8?

If you have a problem with your ignition system, (no spark) that would not be covered. The recall is for warranty extension from, 5yrs 50K to 8yrs 100K, if the engine has lack of power, stalling, low compression and may not be related to your concern.

Yes ATF works good. Yes, do not just start the engine and move car 20 feet and shut off. You need to get the engine warm or hold at 4-5K rpms before shutting off. I put oil in one intake port. could not get the cap off the rear one so I put oil in the lead spark plug holes as the manual said.