How do I setup my Belkin G Wireless Router?

How do I setup my Belkin G Wireless Router?

General Belkin Router Configuration

1. Visit the router’s IP address (http://192.168.2.1) in a new browser window.
2. Click on DNS under Internet WAN.
3. Enter the router’s password and click Submit.
4. Uncheck Automatic from ISP and type in OpenDNS addresses in DNS Address and Secondary DNS Address.
5. Click Apply Changes.

How do I reset my Belkin wireless router password?

Locate the reset button on the back of your Belkin router if you cannot log in to the dashboard at all. Press and hold the button for 15 seconds. This will reset your admin and Wi-Fi password and all router settings, so you will have to log in to the dashboard and customize settings to your needs.

How do I connect my Belkin wifi extender to a new network?

To do this, simply press the range extender’s reset button for at least 10 seconds while it is turned ON. Power cycle the range extender then connect to the network again. Wait for your device to connect to the Belkin. setup network before proceeding to the next step.

How do I reboot my Belkin router?

NOTE: Image may vary depending on the routers model that you are using.

1. Unplug the power cord from the outlet of your router and wait for 30 seconds.
2. Plug the power cord of your router back in and wait for all the lights to activate. You should have successfully restarted your router now.

How do I reinstall my Belkin router?

Reset Button

1. Locate the “Reset” button on the Belkin router.
2. Push the “Reset” button and then release it to reset the router.
3. Push the “Reset” button and hold it for at least 10 seconds to start the “Restore to Factory Defaults” process.
4. Release the button after the 10-second minimum.

Why is my Belkin router blinking orange?

Blinking Orange Light When the orange light on your Belkin router is blinking it means that your router is unable to detect the mode. The possible reasons for that are: The modem is turned off. The modem isn’t connected to the router with a cable.

What are the steps to reset a Belkin router?

With the help of a paper clip or pen,press the reset button on the side of the router. Hold it for a few seconds.

Insert the power cord while pressing the button,and then release it. Configure the router and Wi-Fi settings.

Or you can locate the Utilities section on the left pane.

You will be asked to confirm what all will be restored.

Where is the reset button on this Belkin router?

Carefully look at the back panel of the Belkin device for the reset key.

Now,take a paper clip or any sharp object and then push the reset key.

Press and hold the reset key for like 10-15 seconds.

Make sure the Belkin router is power on and when you see its power LED blinking let the key go.

How to reset Belkin router [solved]?

Soft factory reset a Belkin router: Log into your router as an administrator through 192.168.2.1. Navigate to Administration, select Advanced Settings and select Restore Factory Defaults. On some routers, the options are ‘Router Maintenance’ and ‘Settings’. On other Belkin models, the options are Utilities and Restore Factory Defaults or Restart Router.

How to reset the password for a Belkin router?

Look for the reset button on the rear or side of the router. It appears as a small hole with a recessed button inside.

Insert the end of a paper clip or toothpick into the hole to press the button. Keep pressure on the button for a full 10 seconds.

Pull the paper clip or toothpick out.

Wait approximately one minute.

Launch your computer’s web browser.