How do I reset my EZ GO battery meter?
How to Reset a Golf Cart Battery Meter
- Disconnect the meter from your golf cart.
- Charge your golf cart batteries to 100 percent.
- Connect the meter back to your golf cart to complete the reset process.
How do you know if your golf cart batteries are bad?
Batteries that are having issues will bulge, expand, or even show cracks. Batteries can even leak acid when they have signs of deterioration. Leaking acid can be dangerous or also damage your property. To best protect your batteries, make an effort to wipe down golf cart batteries every month or so.
How do I know if my deep cycle battery is bad?
There are some sure ways you can tell if your battery is bad by simply taking a good look. There are a few things to inspect, such as: a broken terminal, bulge or bump in the case, crack or rupture of the case, excessive leaking, and discoloration. Broken or loose terminals are dangerous, and can cause a short circuit.
How many volts should an EZGO battery pack be?
To get the correct measurement for a normal resting full charge you need to let the batteries sit for twelve hours. Then test with the multimeter the same way and you should get a reading of 38.22 volts. More info on EZGO batteries can be found here.
How long does an EZGO golf cart battery last?
Most batteries last five years, but some may be good for twice that long it properly maintained. If the battery is still good, examine the water level–if it is too low it can make the cart lose power. Fill with distilled water to cover the battery plates up to 1/4 inch below the fill tube.
When did the EZGO 36V marathon resistor come out?
1989 ezgo 36v marathon resistor golf wiring question. I have an old ezgo golf cart that I bought when I moved to a retirement community. After a period of time, it started to have problems shifting from … read more Having an intermittent problem with golf cart not moving.
What to do if your EZGO golf cart is overheating?
This is a common problem with E-Z-Go golf carts and can cause overheating. Have the solenoid replaced by a qualified mechanic. Notice if you are losing power when you drive up inclines. If so, you may need to replace or tighten a battery cable connection. Examine the wiper speed switch for burned-out contacts.