How do I remove SRS?
Steps to remove airbag control module
- First, find the SRS computer module. In most cars, it is under the center console that is between the two front seats, or center of the dash on the floor.
- Disconnect the positive battery cable and wait 3 min.
- You are now safe to unplug the airbag control module harness wiring plugs.
Do you need to replace the SRS module?
In the event the SRS deploys, the airbag module will not function again and must be replaced. As a reminder, the SRS indicator light will stay on continuously after deployment. Only an authorized Honda dealer should repair or replace the system.
Is there a way to reset the SRS light?
You can’t rest the airbag SRS light with a simple OBD II scanner which gives you the check engine light codes. You will need a more advanced scan tool to reset the airbag light. For around $110-150, which is how much a diagnosis costs anyway, you can get your airbag reset tool.
How to remove the SRS airbag control module?
Steps to remove airbag control module 1 First, find the SRS computer module. In most cars, it is under the center console that is between the two front seats, or center of the dash on the floor. 2 Disconnect the positive battery cable and wait 3 min. 3 You are now safe to unplug the airbag control module harness wiring plugs.
Do you have to pay for SRS reset service?
Just Plug & Play! This service is 100% compatible with our seat belt repairs. Some modules referred to as “MCU” modules will require additional programming and chip replacement. Such will incur an additional fee of $15. You agree to potentially be required to pay this up charge.
Is it easy to remove SRS airbag module?
The SRS airbag module is easy to remove and can be done without a professional mechanic. Though we strongly advise knowledgeable individuals removing an SRS module, it can be done at your own risk by following the easy steps: 1.Disconnect the negative terminal of your car’s battery and wait at least 5 minutes before proceeding. 2.
When do you need an SRS module reset?
Whenever you have an airbag code related to the deployment of the airbag, you will always need your SRS module reset. Before, the only solution to this was buying a new module and laying hundreds of dollars at the dealer. Thousands of SRS units would go to trash!
What happens to the SRS module after an accident?
When an accident occurs, the SRS airbag module writes codes in its memory that contain crash information. Once written, this SRS controller becomes “locked” until it is replaced or reprogrammed. This is because the car will no longer be safe to operate.
How to reset the SRS warning light by yourself?
Step 8: You should hear beeps for 3 seconds, and when the beep is gone, the SRS should turn OFF. Step 9: QUICKLY, Take the paperclip/wires out and the light should come back on. Step 10: When the light comes on, QUICKLY plug the paperclip back in to complete the curcuit again, in a second or so, the SRS light should TURN off