How do I know if my Jeep Wrangler has Dana 44?
There are a few things that can help you tell if the axle is a Dana 35 or a Dana 44. The easiest way to tell these axles apart is to look at the shape of the differential cover. The Dana 35 cover is pretty much perfectly round. The Dana 44 is sort of a six-sided shape.
How can you tell if a Dana axle is under a jeep?
You may be unsure which axle is under your Jeep, or maybe you’re purchasing a Jeep and want to know which axle it has. There are a few things that can help you tell if the axle is a Dana 35 or a Dana 44. The easiest way to tell these axles apart is to look at the shape of the differential cover. The Dana 35 cover is pretty much perfectly round.
What’s the difference between Dana 30 and Dana 44 axles?
Aside from the differential covers, the biggest difference between the axles is the size. The number in the name (Dana 30, Dana 44, etc.) is in reference to the sizes of the axle. Dana 30: This axle size is the most common and is usually found on Sport and Sahara models. They have a ring gear diameter of 7 & 1/8”.
How are axles measured on a Wrangler model 44?
The non-Rubicon model 44s are the same length. Axle shafts with a u-joint in the center are measured from the center of the u-joint. Measuring front the center to the end of the shaft will get you the inner and outer axle lengths. C-clip axle shafts and semi-float axle shafts are measured slightly differently than the full-float shafts.
What kind of rear axle does a jeep have?
Most Jeeps in the 90s came with three types of rear axles: Chrysler 8.25, Dana 35 or Dana 44. Some XJ Cherokees have the Dana 44, but its a pretty rare occurrence. ZJ Grand Cherokees with the V8 engine have a Dana 44 rear end, and some of the 4.0-liter ZJ with a tow package do too.
When did Jeep start using the Dana 44 axle?
Earlier CJ-2As and CJ3As did not use the Dana 44. Starting in 1972, the Dana 20 transfer case was used which has the rear output shaft centered, so the rear axle has the differential in the center. From 1972-1975 the Dana 44 was used with a 30 spline flanged axle shaft.
Where do you find model number on Dana 44 differential?
Spicer/Dana 44 rear axles are identified by a casting number stamped into the webbing on the front of the differential case to the driver’s side of the driveshaft. Front axles have a model number cast just below where the right-side axle tube connects to the differential.
Where are the rear axles on a Jeep Wrangler?
Conversely, the Dana 35 is only found as a rear axle for the Jeep Wrangler. This axle version can be identified through its oval-shaped differential cover that is wider than its height. Lastly, Dana’s 44 axle can be found under the front or rear end.
What’s the difference between Dana and Rubicon axles?
This Rubicon axle is referred to as a Super Dana 44. Dana 44 – For TJs, the inner and outer axle has 30 splines. JK Rubicon model front axles have 30 inner splines and 32 outer splines. The rear inner has 32. Note: Rubicon model Dana 44 axles are not the same length as each other due to the design of the electronic lockers.