How do I adjust my SS Super G carb?
Set idle speed adjusting screw, clockwise to increase rpm, counter-clockwise to decrease rpm….Watch the Super E & G Carb Basic Setup video
- Idle mixture screw, 11/4 turns from lightly seated.
- Idle speed screw, ½ turn clockwise from engagement point.
- Accelerator adjustment screw, two turns counter-clockwise from seated.
How to setup a Super E & G carb?
Watch the Super E & G Carb Basic Setup video 1 Verify carburetor is set to stock settings: 2 Idle mixture screw, 11/4 turns from lightly seated. 3 Idle speed screw, ½ turn clockwise from engagement point. 4 Accelerator adjustment screw, two turns counter-clockwise from seated. 5 Start bike, bring to operating temperature.
How to tune a s and S carburetor?
S & S Carburetor Quick tuning Tips 1. Verify carburetor is set to stock settings: a- Idle mixture screw, 1 1/4 turns from lightly seated. b- Idle speed screw, 1/2, turn clockwise from engagement point. c – Accelerator adjustment screw, two turns counterclockwise from seated. 2. Start bike, bring to operating temperature. 3.
What to do if S & S CARB is not turned in?
•If idle mixture screw is turned completely in engine should not run at idle. If engine continues to run at idle with idle mixture screw seated, recheck initial setting of idle speed screw, and make sure enrichment plunger is seated. If engine still runs at idle with idle mixture screw all the in, contact S&S Tech support.
What should my carb screw be set to?
Normally correctly adjusted screw will be between 1 1/4 – 1 ½ turns out from bottom if intermediate jet size is correct. 4. After initial idle mixture adjustment is set, reset engine idle to approximately 1000 RPM. A lower idle speed can cause hard starting; poor throttle response erratic idle and unnecessary engine wear.
S & S Carburetor Quick tuning Tips 1. Verify carburetor is set to stock settings: a- Idle mixture screw, 1 1/4 turns from lightly seated. b- Idle speed screw, 1/2, turn clockwise from engagement point. c – Accelerator adjustment screw, two turns counterclockwise from seated. 2. Start bike, bring to operating temperature. 3.
•If idle mixture screw is turned completely in engine should not run at idle. If engine continues to run at idle with idle mixture screw seated, recheck initial setting of idle speed screw, and make sure enrichment plunger is seated. If engine still runs at idle with idle mixture screw all the in, contact S&S Tech support.
What is the idle mixture screw on a carb?
Idle mixture screw, 11/4 turns from lightly seated. Idle speed screw, ½ turn clockwise from engagement point. Accelerator adjustment screw, two turns counter-clockwise from seated. Start bike, bring to operating temperature. Set idle speed adjusting screw, clockwise to increase rpm, counter-clockwise to decrease rpm.