How do carburetor mixture screws work?
Once the air fuel mixture screws have been properly adjusted, and the engine runs smoothly both at idle, and when revved, it is time to locate the idle mixture screw. The idle mixture screw controls the air fuel mixture at idle speed, and often is located near the throttle plate.
Why is my Mercedes-Benz SL Class not working?
If it is open – the computer thinks the trunk doesn’t have room for the top so it will not operate. Your model of SL does not have the retractable top, but probably still has a similar type system. Try this link – http://mbworld.org/forums/sl-class-r129-18/ this should be a good starting point to finally get the problem resolved
How does the hard top work on a Mercedes SL?
The function of these is controlled by two spring loaded switches in the trunk that MUST BOTH be depressed for operation. Just guessing – your model of SL probably has a similar type system that must be switched for proper installation of the hard top. They are simple spring loaded off/on switches.
How does the defrost button on a Mercedes work?
The defrost button has three lines going through it, while the recirculated air button has a picture of a car with a curved line through it. Hold these buttons down for about five to 10 seconds, or until the LED lights on both buttons start flashing. Wait 45 to 60 seconds for the LED lights to stop flashing. Then turn off the car.
Is the rollbar light on in my 1998 Mercedes SL 500?
1998 Mercedes sl 500 my rollbar light &top light on but top working & rollbar work when open and close top That all happen after battery dead and I try to start T.Y. 30 people found this helpful. schlieve I seem to have the same issue.
How to keep your Mercedes SL Class running smooth?
Keep your fuel injectors clean and your engine running smooth by regularly replacing your fuel filter. Follow these instructions for a cleaner running engine. Use this tech article to replace your fuel reservoir. If you are experiencing erratic acceleration, it may be time to replace the fuel suction dampner.
The defrost button has three lines going through it, while the recirculated air button has a picture of a car with a curved line through it. Hold these buttons down for about five to 10 seconds, or until the LED lights on both buttons start flashing. Wait 45 to 60 seconds for the LED lights to stop flashing. Then turn off the car.
Where is the adjuster screw on a Mercedes?
In order to reach the adjusting screw one must first remove the anti-tamper device required on US cars by Federal law. It is in a cast-aluminum tower just in front of the fuel distributor. Although Mercedes requires that it be removed and discarded, and after the adjustments be replaced by a new one, with care it can be re-used.
What are the problems with a Mercedes Benz?
Top 5 Mercedes-Benz no start problems 1 Engine Click, No Start 2 Engine Dies Right After It Starts 3 Car turns over, but it won’t start 4 The car makes a clicking noise but won’t start. Hint: Starter Problem or Low Battery 5 Key will not turn the ignition More